BFKK
BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
214,99 $
0.00277711BTC
Διαθέσιμο
A-Tech
A-Tech 16GB (2x8GB) DDR4 2666 MHz ECC UDIMM 1Rx8 1.2V CL19 288-Pin Server RAM
ECC UDIMM kit adds 16 GB of DDR4 2666 MHz server memory with CL19 latency and 1.2 V operation
- CAS LatencyCL19
- Rank1Rx8
- Boosts server workload capacity with 16 GB DDR4 kit
- ECC UDIMM protects data integrity in critical applications
- Single-rank 1Rx8 layout optimises memory-channel efficiency
- Standard 1.2 V DDR4 voltage reduces power draw
- 288-pin DIMM fits compatible server and workstation boards
16GB DDR4 ECC UDIMM kit for servers
This 16GB kit contains two 8GB DDR4 2666 MHz ECC UDIMM modules built for servers and workstations. The single-rank 1Rx8 design operates at 1.2V with CL19 latency. It is not compatible with desktop or laptop computers.
Fits DDR4 ECC unbuffered DIMM slots
The 288-pin modules install directly into DDR4 ECC unbuffered DIMM slots on supported server and workstation motherboards. ECC functionality provides error correction for data integrity. The dual-channel kit frees up additional slots for future expansion.
Upgrades from lower-capacity or non-ECC DDR4
Replacing smaller DDR4 kits or non-ECC memory adds capacity and error-correcting protection for critical workloads. The jump is worthwhile when your system supports DDR4 2666 MHz ECC UDIMM and you need improved stability under heavy multi-tasking.
Βασικά χαρακτηριστικά
- Boosts server workload capacity with 16 GB DDR4 kit
- ECC UDIMM protects data integrity in critical applications
- Single-rank 1Rx8 layout optimises memory-channel efficiency
- Standard 1.2 V DDR4 voltage reduces power draw
- 288-pin DIMM fits compatible server and workstation boards
Προδιαγραφές
| CAS Latency | CL19 |
|---|---|
| Rank | 1Rx8 |
Ερωτήσεις για αυτό το προϊόν
Will the CL19 latency become a bottleneck during sustained server workloads?
The modules run at CL19 timing, which is the rated latency for DDR4 2666 MHz operation; sustained throughput will be limited by this CAS figure.
How much heat and power should I expect from the 1.2 V kit when it runs continuously?
Each DIMM operates at the standard 1.2 V DDR4 voltage, so power draw and thermal output remain at typical DDR4 2666 levels for 8 GB single-rank modules.
My motherboard must support ECC UDIMM — what specific interface does this kit require?
The kit uses 288-pin DDR4 ECC unbuffered DIMM slots; the board must accept DDR4 ECC UDIMM memory in a 288-pin form factor.
Επίσης σε αυτό το ράφι
Οι πελάτες σύγκριναν και αυτά
Ίδιο ράφι, ίδιο ταμείο — οκτώ νομίσματα και κλείδωμα ισοτιμίας 30 λεπτών.
