Computer Memory Solutions
Computer Memory Solutions 16GB (2x8GB) DDR3L 1600 SO-DIMM HP Envy M6-1105/06/15Tx
16 GB DDR3L kit (2 × 8 GB) at 1600 MHz CL11 1.35 V for HP Envy M6-1105/1106/1115 models
- Capacity16GB (2 x 8GB)
- Type204-Pin DDR3 SO-DIMM
- SpeedDDR3L 1600 (PC3L 12800)
- CAS LatencyCL11
- Timing11-11-11
- Voltage1.35V
- 16 GB kit (2 × 8 GB) for multitasking headroom
- DDR3L 1600 MHz CL11 timing for responsive performance
- 35 V low-voltage DDR3L reduces power draw
- 204-pin SO-DIMM fits HP Envy M6-1105/06/15Tx
- Unbuffered non-ECC 2Rx8 modules with major-brand chips
What this kit fits
This 16 GB kit contains two 8 GB DDR3L SO-DIMM modules built for the HP Pavilion Envy M6-1105Dx, M6-1106Tx and M6-1115Tx. Each stick runs at 1600 MHz with CL11 timing at 1.35 V. The unbuffered, non-ECC design uses a 204-pin layout and 2Rx8 rank organisation.
Replacing the original memory
The kit upgrades systems that shipped with 4 GB or 8 GB of slower DDR3 memory, filling both SO-DIMM slots for dual-channel bandwidth. The jump is worth it when the laptop feels sluggish with multiple browser tabs, office apps or light creative workloads open at once. Buyers who need more than 16 GB total capacity cannot use this kit.
Installing in the Envy M6
Installation requires removing the bottom service cover, releasing the retention clips on both slots and pressing each module in until it clicks. The low-profile design has no heat spreader, so clearance is not an issue inside the slim chassis. The most common mistake is seating only one side of the module, which leaves the system unbootable until both clips engage fully.
Βασικά χαρακτηριστικά
- 16 GB kit (2 × 8 GB) for multitasking headroom
- DDR3L 1600 MHz CL11 timing for responsive performance
- 35 V low-voltage DDR3L reduces power draw
- 204-pin SO-DIMM fits HP Envy M6-1105/06/15Tx
- Unbuffered non-ECC 2Rx8 modules with major-brand chips
Προδιαγραφές
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM10246412800SODRL |
| Capacity | 16GB (2 x 8GB) |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Timing | 11-11-11 |
| Voltage | 1.35V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Hp Pavilion Envy M6-1105Dx, M6-1106Tx, M6-1115Tx |
| Package Content | 2 Memory RAM Sticks |
Ερωτήσεις για αυτό το προϊόν
Will the 204-pin DDR3L SO-DIMM sticks fit the two memory slots in my HP Envy M6-1105, M6-1106 or M6-1115?
Yes, this 16GB kit is built for those exact models and each module uses the standard 204-pin DDR3L SO-DIMM form factor that matches the two slots in your notebook.
What is the correct way to seat the modules so they do not appear installed but fail to work?
Slide each stick into the slot at the same angle as the key notch, push straight in until the gold edge is fully hidden, then press down evenly until both retention clips snap into the side notches.
Does the 1.35 V DDR3L memory need any firmware update or periodic cleaning to stay reliable?
No firmware or cleaning is required; the JEDEC-standard 1.35 V modules run at CL11 11-11-11 timings and are covered by the manufacturer's limited lifetime warranty.
Επίσης σε αυτό το ράφι
Οι πελάτες σύγκριναν και αυτά
Ίδιο ράφι, ίδιο ταμείο — οκτώ νομίσματα και κλείδωμα ισοτιμίας 30 λεπτών.



