DELL
DELL 400-APZH 960GB 2.5" SATA 6.0Gb/s internal solid state drive
960 GB 2.5" SATA internal solid-state drive for Dell PowerEdge R330 and T330 servers
- PackagingBare Drive
- InterfaceSATA 6.0Gb/s
- Average Latency6Gb/s
- Form Factor2.5"
- 960 GB capacity stores large data volumes
- SATA 6.0 Gb/s interface enables fast transfers
- 5" form factor fits standard drive bays
- Hot-pluggable design allows drive swaps without shutdown
- Compatible with Dell PowerEdge R330 and T330 servers
Capacity and compatibility
The Dell 400-APZH is a 960GB 2.5" internal solid state drive designed for Dell PowerEdge R330 and T330 servers. It uses a SATA 6.0Gb/s interface and arrives as a bare drive without retail packaging. The drive is hot-pluggable for convenient installation.
Sustained transfer behaviour
The SATA 6.0Gb/s interface provides a consistent data transfer rate of up to 600 MB/s under sustained workloads. Average latency is specified at 6Gb/s, reflecting the interface speed rather than a burst-only figure. This makes the drive suitable for steady read and write tasks in supported servers.
SATA interface limits
The SATA 6.0Gb/s standard caps maximum throughput at 600 MB/s, which is the practical ceiling for this drive. It will not exceed that limit regardless of the controller. Buyers needing higher bandwidth should consider drives that use a different interface.
Βασικά χαρακτηριστικά
- 960 GB capacity stores large data volumes
- SATA 6.0 Gb/s interface enables fast transfers
- 5" form factor fits standard drive bays
- Hot-pluggable design allows drive swaps without shutdown
- Compatible with Dell PowerEdge R330 and T330 servers
Προδιαγραφές
| Brand | Dell |
|---|---|
| Model | 400-APZH |
| Packaging | Bare Drive |
| Interface | SATA 6.0Gb/s |
| Average Latency | 6Gb/s |
| Form Factor | 2.5" |
Ερωτήσεις για αυτό το προϊόν
How much power does the 960GB SATA 6.0Gb/s SSD draw during continuous operation?
The drive uses the standard SATA interface and operates within typical 2.5-inch SSD power limits for all-day use.
Does my server need a hot-plug 2.5-inch drive bay to install this 400-APZH drive?
Yes, it is a hot-pluggable 2.5-inch SATA drive designed for compatible Dell PowerEdge bays.
Will this 6Gb/s SATA SSD work in a PowerEdge R330 that currently uses older 3Gb/s drives?
It is compatible with the PowerEdge R330 and T330 and will run at the SATA 6.0Gb/s link speed supported by those servers.
Επίσης σε αυτό το ράφι
Οι πελάτες σύγκριναν και αυτά
Ίδιο ράφι, ίδιο ταμείο — οκτώ νομίσματα και κλείδωμα ισοτιμίας 30 λεπτών.
