Epoch
Epoch 8TB 7200RPM SATA 3.5" Internal Hard Drive Replacement Kit
8 TB 3.5-inch SATA hard drive spinning at 7200 RPM, supplied as a replacement kit for Dell PowerEdge 14 and 15 generation servers
- InterfaceSATA
- Capacity8TB
- RPM7200 RPM
- UsageIdeal for Servers
- Form Factor3.5"
- 8TB capacity stores large server datasets
- 7200 RPM spindle speed delivers fast data access
- SATA 6Gb/s interface ensures broad compatibility
- 5 inch form factor fits standard drive bays
- Compatible with Dell PowerEdge 14 and 15 generation servers
Purpose-built server storage
The Epoch 8TB 7200RPM SATA 3.5" drive is engineered for Dell PowerEdge 14 and 15 Generation servers as well as Dell Tower 15 Generation servers. It delivers high-capacity bulk storage for RAID arrays, backup targets and archival workloads in compatible R240 through R940xa and T150 through T550 platforms.
Thermals and power profile
The 7200 RPM spindle and SATA 6Gb/s interface operate within standard enterprise drive power envelopes for 3.5" bays. Acoustic output and thermal load match expectations for always-on server deployments where drives run continuously under controlled airflow.
The deciding specification
Compatibility is limited to the listed Dell PowerEdge 14 Generation, 15 Generation and Tower 15 Generation models; the drive will not function in systems outside this validated matrix. Buyers who need support for non-Dell servers or earlier generation hardware should select a different drive.
Βασικά χαρακτηριστικά
- 8TB capacity stores large server datasets
- 7200 RPM spindle speed delivers fast data access
- SATA 6Gb/s interface ensures broad compatibility
- 5 inch form factor fits standard drive bays
- Compatible with Dell PowerEdge 14 and 15 generation servers
Προδιαγραφές
| Interface | SATA |
|---|---|
| Capacity | 8TB |
| RPM | 7200 RPM |
| Usage | Ideal for Servers |
| Form Factor | 3.5" |
Ερωτήσεις για αυτό το προϊόν
How do I install the 3.5" SATA drive in a Dell PowerEdge R740 server, and what step is often missed?
Slide the drive into the hot-swap bay until the carrier clicks, then secure the latch; the step often missed is fully engaging the latch so the SATA connector seats on the backplane.
What maintenance or replacement will the 7200 RPM SATA drive need later?
Mechanical drives can develop bad sectors over time; run SMART checks periodically and replace the unit if reallocated-sector counts rise.
What limit appears first on the 8TB SATA drive during sustained write workloads?
The 6 Gb/s SATA interface caps sustained throughput, so sequential write speed will plateau at the link limit before the 7200 RPM media saturates.
Επίσης σε αυτό το ράφι
Οι πελάτες σύγκριναν και αυτά
Ίδιο ράφι, ίδιο ταμείο — οκτώ νομίσματα και κλείδωμα ισοτιμίας 30 λεπτών.
