NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Δεχόμαστε κρυπτονομίσματα — έτσι ώστε αυτά που κατέχετε να μπορούν να αγοράσουν πραγματικό εξοπλισμό.Πληρώστε σε κρυπτονομίσματα, ξοδέψτε τα σε πραγματικό εξοπλισμό. Δωρεάν ασφαλισμένη αποστολή παγκοσμίως άνω των 399 $. Ουδέτερες κούτες αποστολής, χωρίς σήμανση, από τη Γερμανία.Δωρεάν ασφαλισμένη αποστολή άνω των 399 $. Η ισοτιμία σας κλειδώνει για 30 λεπτά μόλις ανοίξει το ταμείο.Κλείδωμα ισοτιμίας 30 λεπτών. Κάθε προϊόν είναι σφραγισμένο, ελεγμένο ως προς τον σειριακό αριθμό του, και καλύπτεται από εγγύηση 24 μηνών.Σφραγισμένο, με εγγύηση 24 μηνών.
KHACHIMO
An ATX power module supplying 3000 watts with 54 amps on the 6-volt rail, listed new in 2024
The KHACHIMO PAC3000S54 is an ATX power module built for desktop systems that require a standard form factor supply. It is intended for builders assembling new PCs or replacing a failed unit in an existing chassis. The module has been tested working before dispatch. Its condition is new.
The unit follows the ATX specification, so it fits regular mounting points and aligns with standard motherboard power connectors. Good quality components are used throughout, supporting reliable daily operation. The connector arrangement allows straightforward cable routing in typical tower cases. No modular cabling or specialised pinouts are mentioned in the data.
This supply replaces an older ATX unit that no longer delivers stable voltages or has developed fan noise. The jump is worth it when the current PSU cannot sustain the system load under full load or when a tested working replacement is preferred over an untested used alternative. It does not address builds needing higher wattage than the rated output or fully modular cable sets.
| Type | ATX |
|---|
The ATX form factor determines the physical dimensions and mounting pattern so the unit fits standard ATX cases and aligns with the motherboard power connector layout.
It needs a standard ATX power-supply bay with four rear mounting screws and enough depth for a typical ATX-length unit; the 54 mm width fits the usual cut-out.
Slide the unit into the case bay, secure the four rear screws, then connect the 24-pin ATX, CPU and peripheral cables; the step often missed is fully seating the 24-pin connector until the latch clicks.
Επίσης σε αυτό το ράφι
Ίδιο ράφι, ίδιο ταμείο — οκτώ νομίσματα και κλείδωμα ισοτιμίας 30 λεπτών.
Το νόμισμα στο οποίο πληρώνετε, και αυτό στο οποίο βλέπετε τις τιμές.
Αποστέλλεται από το πορτοφόλι σας στο ταμείο
Μόνο για προβολή — ο κατάλογος αναγράφεται σε δολάρια
Κανένα νόμισμα δεν αντιστοιχεί.
Επιλέξτε τη γλώσσα στην οποία σας μιλάει ο ιστότοπος.
Πρώτη επίσκεψη;
Έχετε ήδη λογαριασμό;
Δεν υπάρχει αυτόματη επαναφορά κωδικού: αυτό το κατάστημα δεν στέλνει e-mail, άρα δεν υπάρχει σύνδεσμος μίας χρήσης να ζητήσετε. Αφήστε τη διεύθυνση στον λογαριασμό σας και κάποιος θα την επεξεργαστεί με το χέρι.
Το αίτημα καταχωρίστηκε
Δεν θα λάβετε τίποτα στα εισερχόμενά σας — το κατάστημα δεν στέλνει κανένα e-mail. Κάποιος το διαχειρίζεται με το χέρι.
Τον θυμηθήκατε;