BFKK
BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
214,99 $
0.00276149BTC
Διαθέσιμο
Kingston Technology Corp.
Kingston Technology 16GB Kit (Chipkill) DDR2 240-Pin FB-DIMM Memory KTM5780/16G
A 16 GB DDR2 FB-DIMM kit with Chipkill error correction for system-specific upgrades
- Capacity16GB
- Type240-Pin DDR2 SDRAM
- 16 GB capacity in a dual-channel kit for higher bandwidth
- Chipkill error correction protects data integrity in servers
- DDR2 FB-DIMM 240-pin form factor fits compatible systems
- 2 x 8 GB modules enable matched-pair performance
- System-specific design validated for IBM platforms
16 GB FB-DIMM kit for IBM systems
This 16 GB kit contains two 8 GB modules of DDR2 SDRAM built to the 240-pin FB-DIMM form factor. It is designed as a system-specific upgrade for compatible IBM servers and workstations that require Chipkill error correction.
Suited for IBM DDR2 FB-DIMM platforms only
The modules will not fit or function in desktop motherboards, consumer laptops or any system that uses standard unbuffered DDR2 DIMMs. Buyers who need memory for non-IBM hardware or for later DDR generations should look at other products.
Simple module installation with firmware care
Insert each FB-DIMM into the correct memory riser slots following the server service guide, ensuring the ejector clips lock fully. A common issue is the system failing to recognise the new capacity until the BIOS or firmware is updated to the version that supports 8 GB FB-DIMM density.
Βασικά χαρακτηριστικά
- 16 GB capacity in a dual-channel kit for higher bandwidth
- Chipkill error correction protects data integrity in servers
- DDR2 FB-DIMM 240-pin form factor fits compatible systems
- 2 x 8 GB modules enable matched-pair performance
- System-specific design validated for IBM platforms
Προδιαγραφές
| Capacity | 16GB |
|---|---|
| Type | 240-Pin DDR2 SDRAM |
Ερωτήσεις για αυτό το προϊόν
Do I need an IBM server that accepts FB-DIMM 240-pin DDR2 modules for this KTM5780/16G kit to work?
Yes, this 16 GB kit is built for IBM systems that take 240-pin FB-DIMM DDR2 memory.
Can I keep my existing DDR2 FB-DIMM modules and add this 2 x 8 GB kit alongside them?
The kit is system-specific for IBM platforms; mixing is only supported if the server’s memory configuration rules allow matched pairs in the remaining slots.
How can I confirm the full 16 GB is recognised after installing the two 8 GB FB-DIMMs?
Check the server BIOS or operating system memory report — it should show 16 GB total across the two modules.
Επίσης σε αυτό το ράφι
Οι πελάτες σύγκριναν και αυτά
Ίδιο ράφι, ίδιο ταμείο — οκτώ νομίσματα και κλείδωμα ισοτιμίας 30 λεπτών.
