Δεχόμαστε κρυπτονομίσματα — έτσι ώστε αυτά που κατέχετε να μπορούν να αγοράσουν πραγματικό εξοπλισμό.Πληρώστε σε κρυπτονομίσματα, ξοδέψτε τα σε πραγματικό εξοπλισμό. Δωρεάν ασφαλισμένη αποστολή παγκοσμίως άνω των 399 $. Ουδέτερες κούτες αποστολής, χωρίς σήμανση, από τη Γερμανία.Δωρεάν ασφαλισμένη αποστολή άνω των 399 $. Η ισοτιμία σας κλειδώνει για 30 λεπτά μόλις ανοίξει το ταμείο.Κλείδωμα ισοτιμίας 30 λεπτών. Κάθε προϊόν είναι σφραγισμένο, ελεγμένο ως προς τον σειριακό αριθμό του, και καλύπτεται από εγγύηση 24 μηνών.Σφραγισμένο, με εγγύηση 24 μηνών.

Παρακολουθούμενα είδη Σύνδεση
Green bare circuit board with gold edge connectors and black memory chips, no heat spreader

NEMIX RAM

NEMIX RAM 128GB DDR5 6400MHz CL52 2Rx4 1.1V ECC Registered RDIMM GIGABYTE MZ33-CP1 memory upgrade

SKU CH-FAHZ-J7ZPB

A 128 GB DDR5-6400 registered ECC RDIMM at 1.1 V CL52, built for the GIGABYTE MZ33-CP1 server board

  • Capacity128GB
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 6400 (PC5 51200)
  • CAS LatencyCL52
  • Voltage1.10V
  • ECCYes

Size 128GB

Προβολή 24 ακόμη διαμορφώσεων
  • 128 GB capacity lets the GIGABYTE MZ33-CP1 run fully populated at rated speed
  • Registered ECC design corrects single-bit errors on the fly to prevent silent data corruption
  • DDR5 6400 (PC5-51200) CL52 at 1.1 V matches the board's exact timing and voltage requirements
  • 2Rx4 288-pin RDIMM form factor is the specific module type this motherboard accepts
  • Built with major OEM DRAM chips and backed by lifetime replacement support

Exact-match server upgrade

This 128GB DDR5 module is built as a direct drop-in for the GIGABYTE MZ33-CP1 motherboard. It uses the 288-pin RDIMM form factor with registered ECC architecture that the platform expects. The 2Rx4 organisation and 1.10V operating voltage match the board's memory controller requirements exactly. System administrators can install it without configuration guesswork.

Sustained-load stability

Registered buffering reduces electrical load on the memory controller so every slot stays at the rated 6400 speed even when fully populated. ECC corrects single-bit errors on the fly, preventing silent data corruption during long compute runs. The CL52 latency and 1.10V supply are maintained continuously rather than just in short bursts. This combination keeps throughput predictable under constant enterprise workloads.

2Rx4 registered ECC constraint

The module's dual-rank registered ECC design is the single specification that determines compatibility. Boards or CPUs that require UDIMM, SODIMM, single-rank, or non-ECC memory will not accept this part. Verify the motherboard manual for approved DIMM population order and maximum supported capacity before purchase. If the platform does not explicitly support 2Rx4 registered ECC RDIMMs, this upgrade will not function.

Βασικά χαρακτηριστικά

  • 128 GB capacity lets the GIGABYTE MZ33-CP1 run fully populated at rated speed
  • Registered ECC design corrects single-bit errors on the fly to prevent silent data corruption
  • DDR5 6400 (PC5-51200) CL52 at 1.1 V matches the board's exact timing and voltage requirements
  • 2Rx4 288-pin RDIMM form factor is the specific module type this motherboard accepts
  • Built with major OEM DRAM chips and backed by lifetime replacement support

Προδιαγραφές

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR51200-724K1
Capacity128GB
Type288-Pin DDR5 RDIMM
SpeedDDR5 6400 (PC5 51200)
CAS LatencyCL52
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemGIGABYTE
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content128GB DDR5 6400MHz PC5-51200 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Άλλες εκδόσεις αυτού του μοντέλου

5 ακόμη στην ίδια σειρά

Ίδια οικογένεια, διαφορετική μνήμη, ψύκτρα ή συχνότητα — συγκρίνετε πριν αποφασίσετε.

Ερωτήσεις για αυτό το προϊόν

How much heat does the 1.1V DDR5 6400 RDIMM produce when running continuously in a fully populated server?

Operating at 1.1V, the module draws less power per gigabyte than higher-voltage DDR5, so sustained loads generate modest heat; the registered design also reduces electrical loading on the memory controller, helping thermal headroom in dense configurations.

What motherboard slot and firmware support are required for this 288-pin ECC Registered kit to function?

The kit needs a DDR5 RDIMM slot — 288 pins — and a platform that enables registered ECC operation; the GIGABYTE MZ33-CP1 is validated, but any board must explicitly list RDIMM support and the correct population rules in its manual.

Can I mix this 2Rx4 CL52 module with older DDR5 RDIMMs of different rank or latency in the same system?

Mixing ranks or CAS latencies is not recommended; the memory controller will default to the slowest timing and may limit capacity per channel, so populate all slots with identical 2Rx4 CL52 modules for stable full-speed operation.

Επίσης σε αυτό το ράφι

Οι πελάτες σύγκριναν και αυτά

Ίδιο ράφι, ίδιο ταμείο — οκτώ νομίσματα και κλείδωμα ισοτιμίας 30 λεπτών.