upHere
upHere GL28ARGB 5V 3-pin ARGB GPU Brace 280mm
A 280 mm addressable-RGB GPU brace with a sliding rubber pad supports heavy graphics cards and syncs with 5 V 3-pin motherboard headers
- Prevents GPU sag with a 280mm adjustable brace
- Addressable RGB syncs via 5V 3-pin motherboard header
- Sliding rubber pads fit any card and case
- High-quality ABS plastic resists long-term stress
- Light-guide material delivers soft, even illumination for 30000 hours
What It Is
The upHere GL28ARGB is a new GPU support bracket that prevents graphics card sag by bracing the card against the case floor. It suits builders who want addressable RGB lighting and a low-profile holder that works with single or dual-card layouts.
Critical Compatibility
The bracket only accepts a 5 V three-pin addressable RGB header; it will not function on a 12 V four-pin RGB connector. Verify that your motherboard provides a 5 V ADD-RGB header before purchase.
Build Integration
A sliding rubber pad adjusts to different card heights and case clearances, while the 280 mm length spans typical motherboard-to-side-panel distances. Six mounting screws and two spare pads are included for secure installation.
Βασικά χαρακτηριστικά
- Prevents GPU sag with a 280mm adjustable brace
- Addressable RGB syncs via 5V 3-pin motherboard header
- Sliding rubber pads fit any card and case
- High-quality ABS plastic resists long-term stress
- Light-guide material delivers soft, even illumination for 30000 hours
Προδιαγραφές
Δεν έχουν δημοσιευτεί ακόμη προδιαγραφές για αυτό το προϊόν.
Ερωτήσεις για αυτό το προϊόν
How much does the 280 mm length actually support a heavy card in a real build?
The 280 mm brace spans from the motherboard slot area to the card's far edge, and the sliding rubber pad locks against the backplate to stop sag on long triple-fan models.
What does the 5 V 3-pin ARGB header limit in practice?
It only works with motherboards that have a 5 V 3-pin addressable RGB header; 12 V 4-pin RGB headers will not power or control the lighting.
What clearance does the 9 mm height and rubber pad need to fit?
The bracket sits 9 mm tall plus the removable rubber pad, so it fits between the card backplate and the case floor or PSU shroud in most mid-tower builds.
Επίσης σε αυτό το ράφι
Οι πελάτες σύγκριναν και αυτά
Ίδιο ράφι, ίδιο ταμείο — οκτώ νομίσματα και κλείδωμα ισοτιμίας 30 λεπτών.
Black Box Corporation
Black Box Corporation DisplayPort to DVI Fibre Optic Cable 15 ft 4.5 m 1.35 GB/s
- Consumer Electronics
39,99 $
0.00052106BTC
Διαθέσιμο