Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Green circuit board with black memory chips and gold edge connectors

A-Tech

A-Tech 16GB DDR4 2400 ECC UDIMM 2Rx8 for Hynix HMA82GU7AFR8N-UH server RAM

SKU CH-Q3AE-10852

16 GB DDR4 2400 ECC UDIMM 2Rx8 CL17 1.2 V module replaces Hynix HMA82GU7AFR8N-UH and equivalents

  • Capacity16GB
  • SpeedDDR4 2400 (PC4 19200)
  • CAS LatencyCL17
  • Voltage1.20V
  • ECCYes
  • Buffered/RegisteredUnbuffered
  • 16GB DDR4 2400 ECC UDIMM adds capacity for demanding server workloads
  • CL17 latency at 1.20V delivers responsive performance with standard power draw
  • 2Rx8 dual-rank organisation increases memory density per DIMM slot
  • 288-pin unbuffered form factor fits compatible server and workstation boards
  • Major-brand chips and full QA testing ensure dependable operation

16 GB ECC UDIMM for servers

This 16 GB DDR4 module runs at 2400 MHz with CL17 latency and 1.20 V operation. It is built as an unbuffered ECC UDIMM using a 2Rx8 rank layout and major-brand chips. The stick targets administrators who need error-correcting memory for compatible workstation or server boards.

288-pin DIMM with major-brand chips

The standard DDR4 DIMM form factor fits any 288-pin UDIMM slot that accepts ECC unbuffered modules. Major-brand components and factory testing aim to deliver consistent reliability in multi-module configurations. Buyers who need registered or load-reduced DIMMs cannot use this product.

Low-voltage DDR4 thermals

At 1.20 V the module stays within standard DDR4 power limits, helping keep system thermals manageable under sustained workloads. No active cooling is required on the memory itself. Systems with restricted airflow or non-ECC-only memory controllers are not supported.

Põhijooned

  • 16GB DDR4 2400 ECC UDIMM adds capacity for demanding server workloads
  • CL17 latency at 1.20V delivers responsive performance with standard power draw
  • 2Rx8 dual-rank organisation increases memory density per DIMM slot
  • 288-pin unbuffered form factor fits compatible server and workstation boards
  • Major-brand chips and full QA testing ensure dependable operation

Tehnilised andmed

BrandA-Tech
Capacity16GB
SpeedDDR4 2400 (PC4 19200)
CAS LatencyCL17
Voltage1.20V
ECCYes
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor Brand Chipset
FeaturesMajor Brand Chips

Küsimused selle toote kohta

What DDR4 speed and PC4 rating does this ECC UDIMM run at?

This module operates at DDR4 2400 MHz with a PC4-19200 data rate, delivering 1.2V standard voltage and CL17 latency for server workloads.

What physical slot and pin count does this 288-pin DIMM require?

It fits a standard DDR4 UDIMM slot with 288 pins; the 2Rx8 rank layout and unbuffered design match the Hynix HMA82GU7AFR8N-UH form factor exactly.

How do I install this ECC UDIMM and what common step is missed?

Power off the server, open the chassis, align the notch on the 288-pin module with the slot key, press firmly until both retention clips click, then verify in BIOS that ECC is enabled — many forget to enable ECC in firmware after seating the DIMM.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.