Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Green 288-pin DDR4 RDIMM module with black memory chips and gold edge contacts

A-Tech

A-Tech 16GB DDR4 3200 ECC RDIMM 1Rx4 Server Memory

SKU CH-TWNK-14AHJ

16 GB DDR4 3200 ECC registered server DIMM with CL22 latency and 1.2 V operation

  • Capacity16GB
  • SpeedDDR4 3200 (PC4 25600)
  • CAS LatencyCL22
  • Voltage1.20V
  • ECCYes
  • Buffered/RegisteredRegistered
  • 16 GB DDR4 3200 MHz capacity for demanding server workloads
  • ECC RDIMM with CL22 latency ensures data integrity under load
  • Registered 1Rx4 design reduces electrical load on the memory bus
  • Samsung chipset module built to 1.20 V standard voltage for efficiency
  • 288-pin DIMM form factor fits compatible DDR4 server platforms

16GB DDR4 ECC RDIMM for Servers

This 16GB DDR4 3200 module is an A-Tech replacement for Samsung M393A2K40EB3-CWE. It targets servers and workstations that require registered ECC memory for data integrity. The single-rank 1Rx4 organisation suits platforms qualified for this density. Buyers needing unbuffered UDIMMs or non-ECC modules should look elsewhere.

Standard voltage and registered buffering

Operating at 1.20V, the module runs at standard DDR4 voltage without elevated power draw. Registered buffering places a light load on the memory controller, helping stability in multi-DIMM configurations. No active cooling or special airflow is specified; typical server chassis airflow is sufficient. Systems not validated for registered DIMMs will not support this module.

288-pin DIMM with Samsung chipset

The stick uses a 288-pin DDR4 DIMM form factor built on Samsung chipset components. CL22 latency is set at the rated 3200 speed. Installation follows standard keyed DIMM slots; no extra cables or brackets are involved. Verify your platform’s qualified-vendor list for this exact part number before purchase, as unlisted systems may not train the module.

Põhijooned

  • 16 GB DDR4 3200 MHz capacity for demanding server workloads
  • ECC RDIMM with CL22 latency ensures data integrity under load
  • Registered 1Rx4 design reduces electrical load on the memory bus
  • Samsung chipset module built to 1.20 V standard voltage for efficiency
  • 288-pin DIMM form factor fits compatible DDR4 server platforms

Tehnilised andmed

BrandA-Tech
SeriesCompatible Replacement for Samsung
ModelM393A2K40EB3-CWE
Capacity16GB
SpeedDDR4 3200 (PC4 25600)
CAS LatencyCL22
Voltage1.20V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx4
ChipsetSamsung Chipset
FeaturesM393A2K40EB3-CWE

Küsimused selle toote kohta

How do I install this 288-pin DDR4 RDIMM and what step is often missed?

Align the notch on the module with the slot key, press firmly until both retention clips click, then verify the system recognises the full 16 GB at 3200 MHz in BIOS.

What maintenance or replacement will this ECC registered module need over time?

No routine maintenance is required; if a correctable error count rises or the module fails, replace it with another 1Rx4 DDR4 3200 RDIMM of matching voltage.

What limit appears first when this 1.2 V CL22 module runs sustained workloads?

The CAS latency of 22 cycles at 3200 MHz sets the baseline response time; thermal throttling only occurs if chassis airflow cannot dissipate the standard DDR4 power envelope.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.