SanDisk
SanDisk Cruzer Blade 8 GB USB 2.0 USB flash drive Black SDCZ50-008G-B35
391,99 $
0.00501458BTC
Laos
Computer Memory Solutions
Computer Memory Solutions 16GB (2x8GB) DDR4 2400MHz SODIMM CL17 C109
A 16 GB dual-channel DDR4 SODIMM kit running at 2400 MHz CL17, validated for Dell OptiPlex 3050 All-in-One, 7040 Micro and 7440 systems
- Capacity16GB (2 x 8GB)
- Type260-Pin DDR4 SO-DIMM
- SpeedDDR4 2400 (PC4 19200)
- CAS LatencyCL17
- Timing17-17-17
- Voltage1.2V
- 16 GB kit upgrades Dell OptiPlex 3050, 7040 Micro and 7440
- DDR4 2400 MHz speed matches system memory bus
- CL17 latency keeps timing tight for everyday workloads
- 2 V operation reduces power draw and heat
- 260-pin SODIMM form factor fits the listed OptiPlex models
16 GB DDR4 SODIMM kit for Dell OptiPlex
This 16 GB kit contains two 8 GB DDR4 2400 MHz SODIMM modules built for Dell OptiPlex 3050 All-in-One, OptiPlex 7040 Micro and OptiPlex 7440 systems. It is intended for users who need a matched pair to fill both memory slots in these compact desktops.
Thermals noise and power in normal use
The modules run at 1.2 V without a heat spreader, keeping power draw low inside the small chassis of the supported OptiPlex models. Unbuffered, non-ECC operation means no extra controller overhead, so the memory adds minimal heat and no audible noise during typical workloads.
CL17 2Rx8 timing decides fit
CAS latency of 17 with 17-17-17 timing and dual-rank 2Rx8 organisation are the specific parameters that determine whether this kit will work in the listed Dell systems. Buyers whose platforms require a different latency, rank configuration or voltage should look elsewhere.
Põhijooned
- 16 GB kit upgrades Dell OptiPlex 3050, 7040 Micro and 7440
- DDR4 2400 MHz speed matches system memory bus
- CL17 latency keeps timing tight for everyday workloads
- 2 V operation reduces power draw and heat
- 260-pin SODIMM form factor fits the listed OptiPlex models
Tehnilised andmed
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM1024642400SO |
| Capacity | 16GB (2 x 8GB) |
| Type | 260-Pin DDR4 SO-DIMM |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Timing | 17-17-17 |
| Voltage | 1.2V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Dell OptiPlex 3050 All-in-One, OptiPlex 7040 Micro, OptiPlex 7440 |
| Package Content | 2 Memory RAM Sticks |
Küsimused selle toote kohta
How do I install the 260-pin SODIMM modules in a Dell OptiPlex 7040 Micro, and which step do people often miss?
Power off and unplug the system, open the chassis, align the notch on each 8 GB stick with the slot key, press firmly until both side clips click, then verify 16 GB appears in BIOS before closing the case.
What maintenance or replacement will this 1.2 V DDR4 kit need over its service life?
No scheduled maintenance is required; keep vents clear of dust, and if a module fails the manufacturer offers a limited lifetime exchange against manufacturing defects when purchased directly from Computer Memory Solutions.
What limit appears first when the CL17 2400 MHz memory runs sustained workloads in a Dell OptiPlex 7440?
The JEDEC-standard 1.2 V operating voltage and CL17 latency define the thermal and timing ceiling; the modules have no heat spreader, so case airflow becomes the practical limit during prolonged heavy use.
Veel samast osakonnast
Kliendid võrdlesid neid ka
Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.
