SanDisk
SanDisk Cruzer Blade 8 GB USB 2.0 USB flash drive Black SDCZ50-008G-B35
391,99 $
0.00496033BTC
Laos
Computer Memory Solutions
Computer Memory Solutions 16GB DDR4 2666MHz CL19 2Rx8 288-pin DIMM 2-piece kit memory upgrade
Two-piece 16 GB DDR4 kit running at 2666 MHz with CL19 timing and 1.2 V unbuffered DIMMs
- Capacity8GB
- SpeedDDR4 2666 (PC4 21300)
- CAS Latency19
- Timing19-19-19
- Voltage1.2V
- ECCNo
- 16 GB total capacity in a matched 2-piece kit
- DDR4 2666 MHz speed for responsive system performance
- CL19 latency at 1.2 V for efficient operation
- 288-pin unbuffered DIMM fits standard desktop slots
- Lifetime warranty against manufacturing defects
16GB DDR4 2666MHz Kit
This 16GB kit contains two 8GB DDR4 2666MHz modules built for desktop upgrades. Each stick is an unbuffered 288-pin DIMM running at 1.2V with CL19 timing. The set suits users adding capacity to compatible DDR4 systems.
Thermals and Power Draw
Standard DDR4 voltage of 1.2V keeps power draw low during typical workloads. Unbuffered non-ECC modules produce minimal heat under normal desktop use. No active cooling is required for this memory configuration.
Rank and Compatibility
Each module uses a 2Rx8 organisation that determines how the memory controller accesses data. Mixing ranks or speeds forces all modules to run at the slowest installed specification. A 64-bit operating system is needed to address the full 16GB capacity.
Põhijooned
- 16 GB total capacity in a matched 2-piece kit
- DDR4 2666 MHz speed for responsive system performance
- CL19 latency at 1.2 V for efficient operation
- 288-pin unbuffered DIMM fits standard desktop slots
- Lifetime warranty against manufacturing defects
Tehnilised andmed
| Part Number | CM1024642666DIMM |
|---|---|
| Capacity | 8GB |
| Speed | DDR4 2666 (PC4 21300) |
| CAS Latency | 19 |
| Timing | 19-19-19 |
| Voltage | 1.2V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
Küsimused selle toote kohta
How do I install the 288-pin DIMM modules and what step is often missed?
Align the notch on each module with the slot key, press down firmly until both retention clips snap shut, and install the two 8GB sticks as a matched pair in the same-coloured slots for dual-channel operation.
What maintenance or replacement will the 1.2V DDR4 kit need later?
No routine maintenance is required; the modules carry a limited lifetime warranty against manufacturing defects, so replacement would only occur if a defect appears.
What limit appears first when the 2666MHz CL19 memory runs under sustained load?
The CAS latency of 19 cycles at 2666 MHz sets the timing floor, and all installed memory will operate at the slowest module speed or the processor’s maximum supported rate.
Veel samast osakonnast
Kliendid võrdlesid neid ka
Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.
