Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Three 120 mm red case fans with translucent blades and ARGB lighting, shown as a set

COOLMOON

COOLMOON 120mm 3-Pack Case Fan Red 1300RPM 38.5CFM 25dBA Hydro Bearing 4-Pin ARGB Remote

SKU CH-FMXB-QR5FA

Three 120 mm case fans deliver 38.5 CFM at up to 1300 RPM with hydro bearings and 25 dBA noise, plus 380 addressable RGB modes controlled by remote or motherboard sync

  • Fan Counts3 Fans
  • TypeCase Fan
  • Fan Thickness25mm
  • Bearing TypeHydro Bearing
  • RPM0-1300RPM±10%
  • Air Flow38.5CFM

Option 3 Packs

  • 5 CFM airflow cools components efficiently
  • 25 dBA noise keeps the system quiet
  • Hydro bearing runs for 25000 hours
  • 380 RGB modes controlled by wireless remote
  • Music rhythm sync plus 5 V ARGB motherboard sync

Three-Fan Kit for RGB Builds

This COOLMOON kit supplies three 120 mm case fans with hydro bearings and addressable RGB lighting. Each unit spins at up to 1300 RPM and moves 38.5 CFM while staying near 25 dBA. The pack targets builders who want coordinated lighting and basic airflow in a single purchase.

5 V ARGB Motherboard Sync Required

The fans only illuminate when connected to a 5 V three-pin addressable RGB header; they do not work with 12 V four-pin RGB headers. A wireless remote provides 380 lighting modes and music-rhythm sync, but motherboard control depends entirely on the presence of a compatible 5 V ARGB connector.

Remote Controller and Daisy-Chain Cabling Included

A supplied RF remote lets you change colours, speed and modes without software. Ten six-pin fan cables and a four-pin DC power lead allow all three fans to run from one controller. Eight silicone pads per fan dampen vibration, and 48 cm cables reach most mid-tower layouts.

Põhijooned

  • 5 CFM airflow cools components efficiently
  • 25 dBA noise keeps the system quiet
  • Hydro bearing runs for 25000 hours
  • 380 RGB modes controlled by wireless remote
  • Music rhythm sync plus 5 V ARGB motherboard sync

Tehnilised andmed

BrandCOOLMOON
Fan Counts3 Fans
TypeCase Fan
Fan Thickness25mm
Bearing TypeHydro Bearing
RPM0-1300RPM±10%
Air Flow38.5CFM
Noise Level25dBA ±10%
Power Connector4 Pin
ColorRed
LEDRGB

Selle mudeli teised versioonid

1 veel samast sarjast

Sama seeria, erinev mälumaht, jahutus või taktsagedus — võrrelge enne otsustamist.

Küsimused selle toote kohta

What does 38.5 CFM per fan mean for cooling inside my case?

Each fan moves 38.5 cubic feet of air per minute at full speed, so the three-fan pack provides steady airflow across components when all are running at 1300 RPM.

What does the 4-pin connector and 5 V ARGB header requirement mean for my motherboard?

The 4-pin D-type powers the motor at 12 V, while the 5 V 3-pin addressable RGB header controls 380 lighting modes; do not plug the power cable into a 12 V 4-pin RGB header or the fan will burn.

Will these 120 mm fans with 25 mm thickness and 48 cm cables fit my case and reach the controller?

They use the standard 120 mm mounting holes, are 25 mm thick, and each cable is 48 cm long; eight silicone pads on the frame dampen vibration for quieter operation.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.