DELL
DELL 1.92TB SAS 2.5" 12Gb/s RI SSD internal hard drive
A 1.92 TB SAS solid-state drive in a 2.5 inch form factor with a 12 Gb/s interface, shipped with a caddy
- 92 TB capacity supports read-intensive workloads
- 12 Gb/s SAS interface delivers high-throughput data transfer
- 5 inch form factor fits standard drive bays
- Read-intensive design optimises endurance for frequent reads
- Includes R-series caddy for direct server installation
Dell 1.92 TB SAS SSD for servers
This Dell 1.92 TB SAS SSD fits a 2.5 inch bay and connects at 12 Gb/s. It is built for read-intensive workloads in compatible Dell servers and arrays. The drive ships with an R Series caddy for direct installation.
Suits read-heavy server roles
This drive suits database caching, virtualisation hosts and boot volumes that favour reads over writes. It is not for write-heavy logging, heavy video ingest or workloads that exceed its endurance rating. Buyers needing higher write endurance should look at a mixed-use or write-intensive model.
1.92 TB capacity with 12 Gb/s headroom
The 1.92 TB capacity holds operating systems, hypervisors and hot data sets with room for growth. The 12 Gb/s SAS link delivers throughput for multi-VM environments. The drive runs out of space when data sets exceed 1.92 TB and runs out of write cycles under sustained heavy write loads.
Põhijooned
- 92 TB capacity supports read-intensive workloads
- 12 Gb/s SAS interface delivers high-throughput data transfer
- 5 inch form factor fits standard drive bays
- Read-intensive design optimises endurance for frequent reads
- Includes R-series caddy for direct server installation
Tehnilised andmed
Selle toote kohta ei ole veel tehnilisi andmeid avaldatud.
Küsimused selle toote kohta
What SAS controller or backplane do I need to run this 12Gb/s drive?
The drive requires a 12Gb/s SAS controller or backplane with a 2.5" bay; it will negotiate down to 6Gb/s or 3Gb/s if the host link is slower.
Will this 2.5" SAS SSD work in a server that only has 6Gb/s SAS ports?
Yes, the 12Gb/s interface is backward compatible and will operate at 6Gb/s on older SAS ports without any configuration change.
How can I verify the 1.92TB capacity and RI endurance rating after installation?
Check the drive model PX05SRB192Y in your RAID BIOS or OS disk utility; it should report 1.92TB and identify as a Read Intensive SAS SSD.
Veel samast osakonnast
Kliendid võrdlesid neid ka
Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.
