Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
godream PWS-704P-1R redundant ATX power supply 750W

godream

godream PWS-704P-1R Redundant Power Supply 750W

SKU CH-4Y2F-YNTV4

A 750 W redundant ATX power supply for continuous server uptime

  • TypeATX
  • 750 W redundant output keeps systems running if one module fails
  • Hot-swap design lets you replace a unit without shutting down
  • ATX form factor fits standard server and workstation chassis
  • 704 model code identifies the exact replacement part

Redundant 750W ATX power supply

The godream PWS-704P-1R delivers 750 watts through a redundant ATX design that keeps systems running if one module fails. It targets servers and workstations that cannot tolerate unexpected downtime.

Sustained load behaviour

Redundant modules share the load so each unit runs below its maximum rating during continuous operation. This reduces thermal stress and extends component life compared with a single non-redundant supply. Buyers needing hot-swap replacement without a redundant chassis should look elsewhere.

Põhijooned

  • 750 W redundant output keeps systems running if one module fails
  • Hot-swap design lets you replace a unit without shutting down
  • ATX form factor fits standard server and workstation chassis
  • 704 model code identifies the exact replacement part

Tehnilised andmed

TypeATX

Küsimused selle toote kohta

How loud does the PWS-704P-1R get under continuous 750 W load?

The unit uses redundant modules that share the load, so fan speed stays lower than a single 750 W supply would need at full output.

What existing chassis and cabling does the PWS-704P-1R require to operate?

It fits a standard ATX redundant bay and needs the matching 24-pin ATX, 8-pin EPS and peripheral cables already installed in the case.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.