Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Rectangular metal ATX power supply unit with ventilated sides

KHACHIMO

KHACHIMO HWS300-5/WS 5V 60A 300W power supply

SKU CH-18GX-99HD0

Delivers 5 V at up to 60 A for 300 W total output in an ATX form factor

  • TypeATX
  • Delivers 300 W continuous power for demanding 5 V loads
  • 60 A output current supports high-density industrial equipment
  • Switching topology reduces heat and energy loss
  • Tested and verified working before shipment

5 V 60 A switching supply for industrial builds

The KHACHIMO HWS300-5/WS is a 300 W ATX-type switching power supply that delivers a single 5 V rail rated at 60 A. It is intended for system integrators and maintenance teams who need a direct replacement for the TDK-Lambda HWS300-5 in test rigs, automation cabinets or legacy equipment. Each unit is tested working before dispatch.

Thermals noise and power draw in normal use

The supply converts mains input to a regulated 5 V output at up to 300 W continuous load. Internal switching topology keeps heat output proportional to the drawn current, so a lightly loaded unit runs cooler than one near the 60 A limit. Fan noise scales with thermal load and remains within typical industrial tolerances for rack or enclosure mounting.

Põhijooned

  • Delivers 300 W continuous power for demanding 5 V loads
  • 60 A output current supports high-density industrial equipment
  • Switching topology reduces heat and energy loss
  • Tested and verified working before shipment

Tehnilised andmed

TypeATX

Küsimused selle toote kohta

How is the ATX power supply installed, and which connector step is often missed?

Mount the unit in the case, secure it with four screws, then plug the 24-pin ATX motherboard connector and the 4-pin or 8-pin CPU power cable; the CPU power cable is the step most builders forget.

What maintenance will the 300 W unit need later?

Clean dust from the intake grill and fan blades every six to twelve months with compressed air; if the 60 A 5 V rail ever drops out of regulation, the entire supply must be replaced.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.