Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
KHACHIMO ATX power supply unit in black finish

KHACHIMO

KHACHIMO M48300N1 48V 10A to 12V 24V power supply

SKU CH-VG43-1S1SM

Converts 48V 10A input to selectable 12V or 24V output in an ATX form factor

  • TypeATX
  • Converts 48 V input to stable 12 V or 24 V output
  • Delivers up to 10 A for reliable component power
  • ATX form factor fits standard PC chassis
  • Tested working to confirm operational readiness
  • Built with good quality components for durability

What this power supply does

The KHACHIMO M48300N1 converts a 48 volt input at up to 10 amps into selectable 12 volt or 24 volt outputs. It uses an ATX form factor so it fits standard mounting points. The unit is supplied new and has been test-worked by the manufacturer. First listed in 2024, it targets builders who need a compact DC-to-DC step-down solution.

Who this suits and who should look elsewhere

This unit suits integrators converting a 48 volt rail to 12 volt or 24 volt for ATX-compatible systems. It does not suit buyers who need a mains-powered AC-to-DC supply, nor those who require an output voltage other than 12 volt or 24 volt. Builders needing higher current than 10 amps on the input side should consider a different model.

Behaviour under sustained load

The supply is designed for continuous operation at the rated 10 amp input while maintaining either 12 volt or 24 volt output. ATX mounting provides direct chassis contact for heat dissipation during extended runs. Test-working at the factory confirms stable regulation before shipment, so the unit delivers consistent voltage without the droop seen in short-burst testing.

Põhijooned

  • Converts 48 V input to stable 12 V or 24 V output
  • Delivers up to 10 A for reliable component power
  • ATX form factor fits standard PC chassis
  • Tested working to confirm operational readiness
  • Built with good quality components for durability

Tehnilised andmed

TypeATX

Küsimused selle toote kohta

What input voltage source does the M48300N1 require to operate?

The unit expects a 48 V source capable of delivering up to 10 A.

Can the 12 V and 24 V outputs run simultaneously with legacy ATX components?

Both rails are available on the ATX connector, so older peripherals drawing from either voltage will receive power.

How can I verify the supply is functioning correctly after installation?

Measure 12 V and 24 V at the ATX pins with a multimeter while the system is running.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.