Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
KHACHIMO ATX power supply unit u1a-g10075 in metal case

KHACHIMO

KHACHIMO Video Recorder Power Supply u1a-g10075 ATX

SKU CH-E4SB-6FSRM

An ATX power supply tested and verified working for video recorder systems

  • TypeATX
  • ATX form factor fits standard video recorder chassis
  • Tested and confirmed working before dispatch
  • Built with good-quality components for reliable operation
  • Listed by manufacturer in April 2024
  • Model reference u1a-g10075 identifies the exact unit

Video Recorder ATX Power Supply

The KHACHIMO unit is an ATX power supply intended for video recorder systems that require a standard desktop form factor. It delivers the basic voltages needed to run recording hardware and storage drives in a continuous operation environment. This model suits installers who need a direct replacement for an existing ATX supply in a surveillance or DVR chassis.

Tested operation and standard power draw

Each unit is test working before it leaves the supplier, confirming that the rails come up cleanly under normal load. The ATX design means typical power draw follows the demands of the connected recorder motherboard and drives without extra overhead. Noise levels remain consistent with a conventional ATX cooling layout in a rack or tower case.

ATX connector set for recorder builds

The supply uses the standard ATX connector layout, so it fits directly into recorder motherboards that follow the same pinout. Mounting holes match the usual ATX spacing, allowing a straightforward swap in existing enclosures. Build quality is described as good quality, indicating reliable solder joints and component seating for long-term service.

Põhijooned

  • ATX form factor fits standard video recorder chassis
  • Tested and confirmed working before dispatch
  • Built with good-quality components for reliable operation
  • Listed by manufacturer in April 2024
  • Model reference u1a-g10075 identifies the exact unit

Tehnilised andmed

TypeATX

Küsimused selle toote kohta

How is the ATX power supply mounted in a video recorder chassis and which screw pattern should I use?

Secure the unit with four screws through the standard ATX mounting holes on the rear flange; the most common mistake is omitting the bottom screw, which lets the supply shift under vibration.

What maintenance will this power supply need over time?

Clean dust from the ventilation openings periodically and listen for fan bearing noise; the electrolytic capacitors inside will age, so plan to replace the unit if output voltages drift or the recorder becomes unstable.

What limit appears first when the supply runs continuously at full load?

The internal temperature protection will trip before sustained full-load operation can continue indefinitely, causing the unit to shut down until it cools.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.