Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Black 24-pin dual PSU adapter cable with 20+4 main connector, two secondary connectors, 85cm length

myVolts

myVolts ADD3PSU Dual PSU Adapter 24Pin 85cm power supply

SKU CH-2NAM-HW9MM

A dual PSU adapter with one main 24-pin (20+4) and two secondary 24-pin connectors lets three power supplies feed a single motherboard.

  • TypeAT
  • Connect two PSUs for extra power without upgrading hardware
  • 24-pin 20+4 main connector fits 24-pin or 20-pin motherboards
  • Two secondary 24-pin lines let three PSUs feed one board
  • 85 cm cable keeps dual-PSU builds tidy and portable
  • Rated for systems up to 2000 W to stop GPU throttling

Dual PSU adapter for high-draw systems

The myVolts ADD3PSU connects two power supplies to one motherboard using a 24-pin main connector and two 24-pin secondary connectors. It supports 20+4 pin configurations for 24-pin or 20-pin use. Builders running power-hungry graphics cards can add capacity without replacing existing units. The 85 cm cable length suits full-tower layouts.

Sustained load behaviour

The adapter links supplies so they share the system load continuously rather than in brief spikes. It is rated for combined units up to 2000 W, letting multi-GPU or overclocked configurations draw steady current without triggering protection circuits. The thin-wire design maintains stable transmission across the 85 cm run. No active components are present to introduce latency or failure points.

Thermals noise and power draw

The passive ABS and metal construction adds no fan noise or heat of its own. Power draw is limited to the negligible loss across the connectors and 85 cm of wire. Operating temperature follows the power supplies themselves, with no additional thermal load on the motherboard. The compact form factor keeps airflow paths clear in crowded cases.

Põhijooned

  • Connect two PSUs for extra power without upgrading hardware
  • 24-pin 20+4 main connector fits 24-pin or 20-pin motherboards
  • Two secondary 24-pin lines let three PSUs feed one board
  • 85 cm cable keeps dual-PSU builds tidy and portable
  • Rated for systems up to 2000 W to stop GPU throttling

Tehnilised andmed

TypeAT

Küsimused selle toote kohta

Does the 85 cm cable add noticeable heat or power loss when the system runs all day?

The adapter uses a thin-line design for stable transmission and does not generate heat itself; total draw stays within the 2000 W rating of the connected supplies.

What must I already own to use the 24-pin 20+4 main and dual 24-pin secondary connectors?

You need one primary ATX power supply and one or two additional ATX units, each with a standard 24-pin output, plus a motherboard that accepts a 20+4 pin main power plug.

Will the adapter work with an older 20-pin motherboard and legacy power supplies?

Yes, the 20+4 pin main connector separates to fit 20-pin boards, and the secondary 24-pin plugs accept standard ATX outputs from older units.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.