Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Four green DDR5 RDIMM modules without heat spreaders, 288-pin, in a 192GB kit

NEMIX RAM

NEMIX RAM 192GB (4 x 48GB) DDR5 4800 CL40 2Rx8 ECC Registered RDIMM memory upgrade

SKU CH-1DS4-KQ88P

Four 48 GB DDR5 RDIMM modules deliver 192 GB of registered ECC memory at 4800 MT/s with CL40 timing and 1.1 V operation for the Supermicro H13SSL-NT motherboard

  • Capacity192GB (4 x 48GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 192GB 4X48GB

Näita veel 24 konfiguratsiooni
  • 192 GB total capacity from four 48 GB modules
  • DDR5 4800 speed with CL40 latency for rated performance
  • Registered ECC architecture offloads controller and corrects single-bit errors
  • 1 V operation matches server memory-controller requirements
  • 288-pin RDIMM form factor fits Supermicro H13SSL-NT motherboard

192GB DDR5 ECC RDIMM kit

This 192GB kit (4 x 48GB) of DDR5-4800 registered ECC memory is built for servers and workstations that require maximum registered DIMM capacity. It targets administrators upgrading a Supermicro H13SSL-NT motherboard where every slot must run fully populated at rated speed.

Registered buffering and 1.10V operation

The 2Rx8 registered architecture offloads the memory controller so all four slots operate at full capacity without signal degradation. ECC corrects single-bit errors on the fly, preventing silent data corruption and unplanned reboots. Modules run at the standard 1.10V DDR5 voltage with CL40 timing.

288-pin RDIMM form factor for Supermicro H13SSL-NT

These modules use the 288-pin RDIMM form factor required by the Supermicro H13SSL-NT motherboard; they are not compatible with UDIMM or SODIMM slots. No heat spreaders are fitted, leaving maximum clearance for dense server chassis airflow. Verify your system manual for approved DIMM population order before installation.

Põhijooned

  • 192 GB total capacity from four 48 GB modules
  • DDR5 4800 speed with CL40 latency for rated performance
  • Registered ECC architecture offloads controller and corrects single-bit errors
  • 1 V operation matches server memory-controller requirements
  • 288-pin RDIMM form factor fits Supermicro H13SSL-NT motherboard

Tehnilised andmed

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-4828K4
Capacity192GB (4 x 48GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content192GB 4X48GB DDR5 4800MHz PC5-38400 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Selle mudeli teised versioonid

5 veel samast sarjast

Sama seeria, erinev mälumaht, jahutus või taktsagedus — võrrelge enne otsustamist.

Küsimused selle toote kohta

How do I install the 288-pin DDR5 RDIMM modules on the Supermicro H13SSL-NT motherboard, and what step is often missed?

Power down the server, open the chassis, and insert each 48 GB module into the DIMM slots following the board's population order; the step most people miss is consulting the motherboard manual for the exact slot sequence before seating the 2Rx8 registered DIMMs.

What maintenance or replacement will the 192 GB DDR5 ECC RDIMM kit need over its service life?

No routine maintenance is required; the registered ECC design corrects single-bit errors automatically, and the modules are covered by a lifetime replacement warranty if a hardware fault ever develops.

What limit appears first when the 4 x 48 GB DDR5-4800 CL40 kit runs sustained workloads?

The DDR5-4800 speed and CL40 latency are the fixed operating limits; with registered buffering and 1.1 V operation, thermal throttling or bandwidth saturation will appear before any timing or voltage ceiling is reached.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.