Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Green circuit board with black memory chips and gold contacts

NEMIX RAM

NEMIX RAM 8GB DDR4 2933MHz CL21 1Rx8 UDIMM Supermicro X12SAE X12SCA-F memory upgrade

SKU CH-X5AZ-TQPP5

8GB DDR4 2933MHz CL21 UDIMM memory upgrade validated for Supermicro X12SAE and X12SCA-F motherboards

  • Capacity8GB
  • Type288-Pin DDR4 UDIMM
  • SpeedDDR4 2933 (PC4 23400)
  • CAS LatencyCL21
  • Voltage1.20V
  • ECCNo

Size 8GB

  • Exact DDR4-2933 spec match for Supermicro X12SAE/X12SCA-F boards
  • 1Rx8 Non-ECC unbuffered UDIMM installs in standard 288-pin desktop slots
  • Major OEM Samsung, Micron or Hynix chips tested at 1.2 V CL21
  • 8 GB single module adds capacity without mixing ranks
  • Lifetime replacement warranty with US-based technical support

Exact-match DDR4-2933 upgrade for Supermicro

This 8 GB NEMIX RAM module is a 288-pin UDIMM rated at 2933 MHz (PC4-23400) with CL21 latency and 1.20 V operation. It uses a 1Rx8 non-ECC unbuffered layout built from major OEM Samsung, Micron or Hynix chips. The spec matches the memory controller expectations of the listed Supermicro motherboards so the full capacity is recognised at rated speed.

Check motherboard manual for DIMM population rules

Desktop and motherboard memory support varies by model so consult the system or board manual for supported capacities and approved DIMM population order before purchase. Verify that the board accepts non-ECC unbuffered UDIMMs and that an 8 GB 1Rx8 module fits the intended slot configuration. No heat spreader is fitted so ensure case airflow is adequate for the memory area.

Suits owners of X12SAE

Builders who need ECC registered modules or SODIMM form factor should look elsewhere. Buyers wanting higher capacity per slot or lower latency timings than CL21 will need different modules. Systems requiring a different DDR generation or voltage are not compatible with this kit.

Põhijooned

  • Exact DDR4-2933 spec match for Supermicro X12SAE/X12SCA-F boards
  • 1Rx8 Non-ECC unbuffered UDIMM installs in standard 288-pin desktop slots
  • Major OEM Samsung, Micron or Hynix chips tested at 1.2 V CL21
  • 8 GB single module adds capacity without mixing ranks
  • Lifetime replacement warranty with US-based technical support

Tehnilised andmed

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR4 Non-ECC Unbuffered UDIMM Memory
Part NumberMD23400-818K1
Capacity8GB
Type288-Pin DDR4 UDIMM
SpeedDDR4 2933 (PC4 23400)
CAS LatencyCL21
Voltage1.20V
ECCNo
Buffered/RegisteredUnbuffered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR4 Non-ECC Unbuffered UDIMM Motherboard Compatible
Package Content8GB DDR4 2933MHz PC4-23400 1Rx8 1.2V 288-PIN Non-ECC UDIMM KIT

Selle mudeli teised versioonid

5 veel samast sarjast

Sama seeria, erinev mälumaht, jahutus või taktsagedus — võrrelge enne otsustamist.

Küsimused selle toote kohta

Does the box contain just the 8GB DDR4 2933MHz UDIMM or are cables and tools included?

The package contains only the single 8GB DDR4 2933MHz PC4-23400 1Rx8 1.2V CL21 288-pin Non-ECC Unbuffered UDIMM module. No cables, screws or installation tools are supplied.

Should I choose the 1Rx8 CL21 version or look for a dual-rank or lower-latency alternative for the Supermicro X12SAE?

The X12SAE and X12SCA-F memory controller expects exactly this 1Rx8 Non-ECC Unbuffered UDIMM at 1.2V CL21. A dual-rank or different CAS latency module may not be recognised or may run at reduced speed.

Will the rated 2933MHz speed actually be reached once the module is installed in the X12SAE motherboard?

Yes. The module is spec-matched to the Supermicro X12SAE and X12SCA-F population rules, so the board will detect it at full 8GB capacity and operate it at the rated DDR4 2933MHz PC4-23400 speed with CL21 timing.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.