Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Two green DDR5 UDIMM sticks, no heat spreader, gold contacts, 288 pins, sold as a 32GB kit

NEMIX RAM

NEMIX RAM DDR5 5600 32GB (2x16GB) ECC UDIMM CL46 1.1V Supermicro X14SAZ-F

SKU CH-7R2T-9Y8YQ

32 GB DDR5 ECC UDIMM kit (2×16 GB) at 5600 MT/s, CL46, 1.1 V, verified for Supermicro X14SAZ-F

  • Capacity32GB (2 x 16GB)
  • Type288-Pin DDR5 ECC UDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes

Size 32GB 2X16GB

  • ECC corrects single-bit errors to prevent data corruption
  • DDR5 5600 speed matches the Supermicro X14SAZ-F memory controller
  • 32 GB kit (2 × 16 GB) fills two slots at rated capacity
  • 1 V operation meets the platform's voltage spec
  • 288-pin UDIMM form factor fits the motherboard's DIMM sockets

Exact-match upgrade for Supermicro X14SAZ-F

This 32GB kit contains two 16GB DDR5 5600 modules built to the CL46 1.1V 1Rx8 specification the board expects. ECC unbuffered UDIMM format provides error correction without registered buffering. The modules install directly into the 288-pin slots and run at the rated PC5-44800 speed.

Check your motherboard manual before ordering

Verify the maximum capacity per slot and the approved DIMM population order for the X14SAZ-F. Confirm the platform requires unbuffered ECC UDIMMs rather than RDIMM or SODIMM variants. Ensure the BIOS version installed supports the full 5600MHz data rate at 1.1V.

No heat spreader, standard 288-pin connectors

Bare PCB modules fit tight clearance around CPU coolers and allow visual inspection of the major-brand Samsung, Micron or Hynix chips. The 1.1V operating voltage matches the DDR5 baseline for lower power draw. Unbuffered topology keeps latency low for workloads that benefit from direct memory access.

Põhijooned

  • ECC corrects single-bit errors to prevent data corruption
  • DDR5 5600 speed matches the Supermicro X14SAZ-F memory controller
  • 32 GB kit (2 × 16 GB) fills two slots at rated capacity
  • 1 V operation meets the platform's voltage spec
  • 288-pin UDIMM form factor fits the motherboard's DIMM sockets

Tehnilised andmed

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 ECC Unbuffered UDIMM Memory
Part NumberME44800-618K2
Capacity32GB (2 x 16GB)
Type288-Pin DDR5 ECC UDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredUnbuffered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC Unbuffered UDIMM Motherboard Compatible
Package Content32GB 2X16GB DDR5 5600MHz PC5-44800 1Rx8 1.1V 288-PIN ECC UDIMM KIT

Selle mudeli teised versioonid

5 veel samast sarjast

Sama seeria, erinev mälumaht, jahutus või taktsagedus — võrrelge enne otsustamist.

Küsimused selle toote kohta

Does the kit include anything besides the two 16 GB DDR5 5600 ECC UDIMM modules?

No, the package contains only the two 288-pin DIMMs that make up the 32 GB kit. No heat spreaders, cables or documentation are listed.

Is the CL46 1.1 V 1Rx8 specification the only version available for this board?

Yes, this part number ME44800-618K2 is built to the exact rank, voltage and timing the Supermicro X14SAZ-F memory controller expects.

Will the memory run at the full 5600 MT/s speed once installed in the X14SAZ-F?

The modules are spec-matched to the board's DDR5 5600 PC5-44800 requirement, so the controller will recognise them at full capacity and rated speed.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.