Oncore Power Systems, Inc.
Oncore Power Systems, Inc. FJ5G4LCLC-01M fibre optic cable
A one-metre OM4 fibre optic cable with LC-LC duplex connectors for 100G multimode links
- TypeOthers
- Connector Number1
- 1 metre OM4 fibre link ready for 100 GbE speeds
- LC to LC duplex connectors for multimode patching
- Single connector assembly simplifies installation
- Unirise manufacture ensures consistent build quality
- First listed June 15 2021 as current model
1m OM4 LC-LC fibre cable
This 1-metre OM4 fibre optic cable uses LC-LC connectors and is built for multimode links rated at 100G. It suits data-centre patches, campus backbones or any short-run 100G connection where OM4 bandwidth is specified.
Installers needing a single 1m duplex patch
The cable provides one connector assembly, so it fits point-to-point links between transceivers or patch panels. Buyers who need longer reaches, higher fibre counts, single-mode variants or pre-terminated trunk cables should look at other products.
100G multimode headroom over 1m
OM4 bandwidth comfortably supports 100G Ethernet across the full 1-metre length with ample margin for connector loss. The cable runs out of reach for links beyond the OM4 distance limit for 100G or for any application requiring single-mode performance.
Põhijooned
- 1 metre OM4 fibre link ready for 100 GbE speeds
- LC to LC duplex connectors for multimode patching
- Single connector assembly simplifies installation
- Unirise manufacture ensures consistent build quality
- First listed June 15 2021 as current model
Tehnilised andmed
| Brand | Unirise |
|---|---|
| Type | Others |
| Connector Number | 1 |
| Tarnekaal | 0.45 kg |
| Pakendi mõõtmed | 203 × 178 × 25 mm |
Küsimused selle toote kohta
What transceivers must I already have to use this LC-LC OM4 cable?
You need a pair of LC duplex transceivers that support OM4 multimode fibre and the data rate you intend to run.
Can this 100G-rated OM4 cable connect to legacy 10G LC ports I plan to keep?
Yes — the LC connectors are the same physical interface, so the cable plugs into older 10G LC ports as long as the transceivers match the fibre type.
How can I confirm the 1-metre link is performing at 100G after installation?
Run a link-light check on both transceivers and verify zero bit errors with a traffic generator or the switch port statistics.
Veel samast osakonnast
Kliendid võrdlesid neid ka
Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.
Black Box Corporation DisplayPort to DVI Fibre Optic Cable 15 ft 4.5 m 1.35 GB/s
- Consumer Electronics



