Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Green bare circuit board with black memory chips and gold edge contacts

OWC

OWC 8GB DDR4 2666MHz CL19 1.2V 288-Pin UDIMM for HP OMEN X 900-290nf 900-290nz 900-299nd

SKU CH-FECH-HC801

8GB DDR4 2666MHz CL19 1.2V UDIMM for HP OMEN X 900-290nf 900-290nz 900-299nd desktop upgrade

  • Capacity8GB
  • Type288-Pin DDR4 Non-ECC UDIMM
  • SpeedDDR4 2666 (PC4 21300)
  • CAS LatencyCL19
  • Voltage1.2V
  • ECCNo
  • 8GB DDR4 2666MHz CL19 boosts system responsiveness
  • 2V low-voltage design reduces power draw
  • 288-pin UDIMM fits HP OMEN X 900-290nf, 900-290nz, 900-299nd
  • JEDEC and RoHS compliant for warranty-safe upgrade
  • Backward compatible with 2133MHz and 2400MHz systems

HP OMEN X 900 compatible DDR4 UDIMM

This 8GB DDR4 2666MHz CL19 module is built specifically for HP OMEN X 900-290nf, 900-290nz and 900-299nd desktops. It suits owners of those systems who want a straightforward capacity increase. Buyers with other motherboards or laptops should verify their exact memory requirements before purchasing.

DDR4 2666MHz JEDEC standard limits

The module runs at the standard 1.2V JEDEC voltage with CL19 timings and will down-clock to 2400MHz or 2133MHz if the platform demands it. It does not support XMP profiles, ECC error correction or registered buffering. Systems requiring registered DIMMs or higher factory speeds cannot use this stick.

Simple DIY installation with common pitfalls

Installation follows the usual UDIMM procedure: power off, open the case, align the notch and press until the clips latch. The most frequent issues are mixing speeds across channels, leaving a slot unpopulated in a dual-channel board, or forgetting to seat the module fully so the system fails to POST.

Põhijooned

  • 8GB DDR4 2666MHz CL19 boosts system responsiveness
  • 2V low-voltage design reduces power draw
  • 288-pin UDIMM fits HP OMEN X 900-290nf, 900-290nz, 900-299nd
  • JEDEC and RoHS compliant for warranty-safe upgrade
  • Backward compatible with 2133MHz and 2400MHz systems

Tehnilised andmed

BrandOWC
Part Number2U6D41R808GB
Capacity8GB
Type288-Pin DDR4 Non-ECC UDIMM
SpeedDDR4 2666 (PC4 21300)
CAS LatencyCL19
Voltage1.2V
ECCNo
Buffered/RegisteredUnbuffered
Rank1Rx8
Heat SpreaderNo
Compatible SystemHP OMEN X 900-290nf
HP OMEN X 900-290nz
HP OMEN X 900-299nd

Selle mudeli teised versioonid

5 veel samast sarjast

Sama seeria, erinev mälumaht, jahutus või taktsagedus — võrrelge enne otsustamist.

Küsimused selle toote kohta

Should I pick the 8 GB module or add a second stick for dual-channel?

The module is a single 8 GB stick. Adding a second identical module enables dual-channel bandwidth on the OMEN X 900-290nf, 900-290nz and 900-299nd platforms.

What does the 2666 MHz rating deliver inside my OMEN X 900-290nf?

The memory runs at 2666 MHz with CL19 timing at 1.2 V. If the system BIOS only supports 2133 MHz or 2400 MHz, the stick will down-clock automatically to match.

Is the 288-pin DDR4 UDIMM interface the limiting factor for speed?

The 288-pin unbuffered DDR4 form factor carries the PC4-21300 signal. The practical ceiling is the 2666 MHz JEDEC rating; the slot itself does not impose a lower limit.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.