Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Silver 3.5 inch SCSI hard drive with 80-pin connector

Seagate

Seagate Barracuda 18XL ST318436LC 18.4GB 7200RPM Ultra-160 SCSI 80-Pin 2MB 3.5" internal hard drive

SKU CH-4CEZ-42JER

18.4 GB internal 3.5 inch hard drive spinning at 7200 RPM with Ultra-160 SCSI 80-pin interface and 2 MB cache

  • 4 GB capacity stores large datasets
  • 7200 RPM spindle speed enables quick data access
  • Ultra-160 SCSI interface delivers 160 MB/s throughput
  • 2 MB cache buffers frequent read operations
  • 80-pin SCA connector simplifies hot-swap installation

18.4 GB Ultra-160 SCSI drive

This 18.4 GB internal hard drive uses a 3.5-inch Ultra-160 SCSI 80-pin interface and spins at 7200 RPM. A 2 MB buffer handles burst transfers for legacy servers or workstations that still require wide SCSI connectivity. It suits administrators maintaining older arrays or replacing failed drives in certified configurations.

Thermals noise and power in normal use

The drive operates at standard 3.5-inch form-factor power levels with a 7200 RPM spindle. Acoustic output and thermal load are consistent with enterprise SCSI drives of this generation. No active cooling beyond typical chassis airflow is specified by the manufacturer.

Build integration requirements

An 80-pin SCA-2 backplane or adapter supplies both data and power through a single connector. The unit fits any 3.5-inch bay with the correct SCSI termination and ID configuration. It frees a standard 4-pin Molex connector but requires a compatible Ultra-160 host bus adapter or RAID controller.

Põhijooned

  • 4 GB capacity stores large datasets
  • 7200 RPM spindle speed enables quick data access
  • Ultra-160 SCSI interface delivers 160 MB/s throughput
  • 2 MB cache buffers frequent read operations
  • 80-pin SCA connector simplifies hot-swap installation

Tehnilised andmed

Selle toote kohta ei ole veel tehnilisi andmeid avaldatud.

Küsimused selle toote kohta

How do I install the 80-pin Ultra-160 SCSI drive into a 3.5-inch bay and what step is often missed?

Slide the drive into the hot-swap carrier or backplane until the 80-pin connector seats firmly; the step often missed is setting a unique SCSI ID via the jumpers on the drive before powering on.

What maintenance or replacement will the ST318436LC need over time?

The 7200 RPM motor and bearings are the primary wear items; after years of continuous operation the drive may develop seek noise or SMART reallocated-sector counts that signal replacement.

What limit appears first during sustained transfers on this 18.4 GB Ultra-160 SCSI drive?

The 2 MB buffer fills quickly, so the sustained throughput ceiling is the physical media transfer rate of the 7200 RPM platters rather than the 160 MB/s bus limit.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.