Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Small black 50 by 15 mm case fan with two wires

Zyvpee

Zyvpee ME50151V3-000C-A99 50×15 mm 12 V 0.78 W 2-wire Maglev case fan

SKU CH-VPCW-NQQT4

A 50 mm by 15 mm Maglev CPU cooler fan running at up to 1600 RPM on 12 V and 0.78 W

  • TypeCPU Cooler Fan
  • CompatibilityCPU Cooler
  • Bearing TypeMaglev
  • RPM<1600 RPM
  • Power Connector2 Wires
  • ColorBlack
  • Maglev bearing reduces friction and noise for longer life
  • 12 V 0.78 W draw keeps power use low in tight builds
  • 50 × 15 mm footprint fits compact CPU coolers and small cases
  • Two-wire connector simplifies installation on standard headers
  • Sub-1600 RPM operation delivers quiet airflow for focused cooling

Compact 50 mm CPU cooler fan

The Zyvpee ME50151V3-000C-A99 is a 50 by 15 millimetre fan built for CPU cooler mounting. It runs on twelve volts and draws zero point seven eight watts through a two-wire lead. Maglev bearing keeps friction low at speeds below sixteen hundred RPM.

Two-wire power connector

The single specification that decides fit is the two-wire power connector. It supplies constant twelve-volt power without PWM control or tachometer feedback. Builders who need speed reporting or motherboard-controlled curves cannot use this unit.

Fits tight cooler stacks

The fifty by fifteen millimetre frame slides into narrow CPU cooler stacks where larger fans will not mount. Two-wire operation frees the builder from PWM header count but removes automatic speed scaling. Non-LED black finish stays neutral in any build.

Põhijooned

  • Maglev bearing reduces friction and noise for longer life
  • 12 V 0.78 W draw keeps power use low in tight builds
  • 50 × 15 mm footprint fits compact CPU coolers and small cases
  • Two-wire connector simplifies installation on standard headers
  • Sub-1600 RPM operation delivers quiet airflow for focused cooling

Tehnilised andmed

BrandZyvpee
SeriesME50151V3-000C-A99
ModelME50151V3-000C-A99
TypeCPU Cooler Fan
CompatibilityCPU Cooler
Bearing TypeMaglev
RPM<1600 RPM
Power Connector2 Wires
ColorBlack
LEDNon-LED
FeaturesCPU Cooling
Dimensions50*15MM

Küsimused selle toote kohta

How much airflow can I expect from a fan rated below 1600 RPM in a typical case?

The fan spins up to 1600 RPM, delivering a focused stream of air through its 50 mm frame; actual airflow depends on the cooler or case restriction it is mounted on.

What does the 2-wire power connector limit for speed control?

With only two wires the fan runs at full 12 V speed whenever powered; there is no PWM or voltage-control signal to vary RPM.

Will the 50 by 15 mm dimensions fit my CPU cooler mounting holes?

The fan measures 50 mm square and 15 mm thick, matching the standard 5015 footprint used on many small CPU coolers; verify your cooler’s hole spacing before fitting.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.