BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
A-Tech
8GB DDR4 2133MHz CL15 SODIMM laptop memory upgrade compatible with Micron part numbers
This 260-pin DDR4 module delivers 8GB of memory at 2133MHz with CL15 latency. It operates at the standard 1.20V and uses an unbuffered, non-ECC design. The stick is built as a direct replacement for specific Micron part numbers including MTA16ATF1G64HZ-2G1 and MTA8ATF1G64HZ-2G1. It targets users upgrading compatible AMD or Intel based laptops, notebooks, or all-in-one systems.
The module uses the industry standard 260-pin SO-DIMM edge connector, allowing it to seat directly into compatible DDR4 laptop memory sockets. Its low-profile design clears typical chassis constraints found in thin-and-light notebooks. Each unit undergoes quality assurance testing to verify reliable operation before shipping. Buyers must confirm their system supports DDR4 SO-DIMM memory and the specific speed before purchase.
The PC4-17000 rating defines the maximum theoretical transfer rate of this interface. Systems limited to lower memory speeds will downclock the module automatically, reducing available bandwidth. Platforms requiring ECC or registered memory cannot use this unbuffered non-ECC stick. The single 8GB rank may limit total capacity on boards with only one slot or a low maximum memory ceiling.
| Brand | A-Tech |
|---|---|
| Capacity | 8GB |
| Type | 260-Pin DDR4 SO-DIMM |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Recommend Use | AMD & Intel Compatible |
The module runs at 2133 MT/s with CL15 latency at the standard 1.20V DDR4 voltage; the PC4-17000 label confirms the peak transfer rate of 17 GB/s.
It installs in a standard 260-pin DDR4 SO-DIMM socket; the single notch position matches the DDR4 key so it only fits one way.
Many forget to press the module firmly until both side clips click shut; a loose seat causes boot failures even though the gold contacts look inserted.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Nincs egyező nyelv.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?