NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
Computer Memory Solutions
Four-module kit adds 16 GB of DDR2-667 ECC registered memory to a Dell PowerEdge 2850 server
This 16GB kit contains four 4GB DDR2 registered ECC modules built for the Dell PowerEdge 2850. Each stick runs at 667 MHz with CL5 timing at 1.8V. The 240-pin DIMMs use a 2Rx4 organisation and are validated for the server’s six-slot architecture.
Registered buffering reduces electrical load on the memory controller when all six sockets are populated. ECC corrects single-bit errors in real time, preventing silent data corruption during long compute runs. The dual-rank layout lets the chipset interleave accesses across ranks for steadier throughput under continuous demand.
Replacing a partial kit or non-ECC memory with this matched set reaches the platform’s 16GB ceiling and enables the full eight-rank limit the chipset supports. The jump is worthwhile when workloads need maximum capacity with error correction rather than raw speed. Builders needing higher frequencies or larger single modules must choose a newer platform.
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM512725300ECCREG2R4 |
| Capacity | 16GB (4 x 4GB) |
| Type | 240-Pin DDR2 SDRAM |
| Speed | DDR2 667 (PC2 5300) |
| CAS Latency | CL5 |
| Timing | 5-5-5 |
| Voltage | 1.8V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
| Heat Spreader | Based on Current Inventory (If Required Please Contact) |
| Compatible System | Dell Poweredge 2850 |
| Package Content | 1 Memory RAM Stick |
Each module operates at 1.8 V, the standard voltage for DDR2-667 registered ECC DIMMs.
The kit is guaranteed compatible with the PowerEdge 2850; the first DIMM may be populated singly and additional memory must be added in pairs.
The chipset supports a maximum of eight ranks, so mixing is possible within that limit, but all modules must be registered ECC DDR2.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?