OWC 1R6T31R4016P 16GB (2x8GB) DDR3L 1600 CL11 ECC RDIMM memory upgrade
- 16GB (2 x 8GB)
- 240-Pin DDR3L ECC R…
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
OWC
ECC registered DDR3L 1600 kit adds 16 GB across two 8 GB modules for compatible Supermicro server boards
Capacity 16GB (2 x 8GB)
This OWC kit supplies 16 GB of DDR3L ECC registered memory in two 8 GB modules. It is built for Supermicro H8DCT, H8DG6, H8DGT, H8DGU and H8QG7 motherboards used in workstations, servers and NAS appliances. The modules run at 1600 MHz with CL11 latency at 1.35 V. They are not compatible with standard desktop computers.
Verify that your motherboard is one of the listed Supermicro series and that it supports DDR3L ECC registered DIMMs. Do not mix these registered modules with unbuffered memory. Confirm the board has free 240-pin slots and that the BIOS recognises 1Rx4 registered population rules.
Each module uses a 240-pin DDR3L form factor without a heat spreader. The registered design adds a buffer that reduces electrical load on the memory controller in multi-DIMM configurations. ECC circuitry detects and corrects single-bit errors during operation. The low-profile PCB fits standard server DIMM sockets without clearance issues.
| Brand | OWC |
|---|---|
| Part Number | 1R6T31R4016P |
| Capacity | 16GB (2 x 8GB) |
| Type | 240-Pin DDR3L ECC RDIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 1Rx4 |
| Heat Spreader | No |
| Compatible System | Supermicro Motherboard H8DCT Series Supermicro Motherboard H8DG6 Series Supermicro Motherboard H8DGT Series Supermicro Motherboard H8DGU Series Supermicro Motherboard H8QG7 Series |
A modell további verziói
Ugyanaz a termékcsalád, eltérő memória, hűtés vagy órajel — hasonlítsa össze, mielőtt dönt.
The kit includes two 8GB DDR3L 1600 ECC Registered RDIMM modules for a total of 16GB. No additional components are required for installation on supported Supermicro boards.
This 1Rx4 1.35V kit is validated for Supermicro H8DCT, H8DG6, H8DGT, H8DGU and H8QG7 series motherboards. Select the kit if your board belongs to one of those series.
The modules run at 1600 MT/s with CAS latency 11 at 1.35V, delivering ECC error correction and registered buffering for stable operation in compatible Supermicro workstations and servers.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Nincs egyező nyelv.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?