Seagate
Seagate Nytro 1361 960 GB 2.5" SATA internal SSD
960 GB 2.5" SATA internal SSD with 3D eTLC NAND rated for 1 DWPD, 1,829 TB endurance, 530 MB/s read, 500 MB/s write, 94,000 random read IOPS, 62,000 random write IOPS, 2,000,000-hour MTBF.
- Device TypeInternal Solid State Drive (SSD)
- 960 GB capacity fits large data sets
- SATA 6Gb/s interface delivers 530 MBps read and 500 MBps write
- 1 DWPD endurance rated at 1829 TB total writes
- 94000 random read and 62000 random write IOPS for mixed workloads
- 5" form factor with 1.6 W idle and 4.5 W average power
960 GB SATA SSD for enterprise workloads
The Seagate Nytro 1361 is a 960 GB internal solid-state drive built for 24x7 continuous operation. It uses 3D enterprise triple-level cell NAND and a SATA 6Gb/s interface to deliver 530 MBps sequential read and 500 MBps sequential write speeds. Random performance reaches 94000 IOPS read and 62000 IOPS write at 4 KB. The drive is rated for 1 drive write per day and 1829 TB total endurance.
Installation and common issues
The drive fits any standard 2.5 inch SATA bay and connects with a single SATA 6 Gb/s cable. No special drivers are required for modern operating systems. The most common issue is connecting the drive to a 3 Gb/s port, which halves the available throughput. Ensure the SATA controller is set to AHCI mode in firmware for full performance and hot-plug support.
Pre-order checks
Verify that your system has a free 2.5 inch drive bay and an available SATA 6 Gb/s port on the motherboard or controller card. Confirm the power supply can deliver the required 4.5 W average and 1.6 W idle power over a standard SATA power connector. Check that the chassis airflow can keep the drive within its operating temperature range during sustained 24x7 workloads.
Erősségek
- 960 GB capacity fits large data sets
- SATA 6Gb/s interface delivers 530 MBps read and 500 MBps write
- 1 DWPD endurance rated at 1829 TB total writes
- 94000 random read and 62000 random write IOPS for mixed workloads
- 5" form factor with 1.6 W idle and 4.5 W average power
Műszaki adatok
| Device Type | Internal Solid State Drive (SSD) |
|---|
Kérdések a termékről
Will this 2.5" SATA drive fit in my server's 2.5" hot-swap bay?
The drive uses the standard 2.5" form factor and a single SATA 6 Gb/s connector, so it will seat in any 2.5" bay that accepts SATA SSDs.
Is the 960 GB capacity and 1 DWPD rating enough for a write-heavy database running 24/7?
With 1829 TB total endurance and a 1 DWPD rating, the drive is specified for 24x7 continuous operation at that write level.
What power budget should I plan for when adding several of these drives?
Each unit draws 1.6 W at idle and 4.5 W on average, so multiply those figures by the number of drives for your total estimate.
Szintén ezen a polcon
Vásárlók ezeket hasonlították össze
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
