BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
SerialGear
Adds two isolated RS-422/485 serial ports via a 32-bit CardBus or 16-bit PCMCIA 7.1 slot with 16C950 UARTs and auto transceiver turn-around up to 921.6 Kbps
The SerialGear SG-RS2SIS adds two isolated serial ports to any system with a 32-bit CardBus Type-II or 16-bit PCMCIA R7.1 slot. It targets engineers and technicians who need reliable RS-422 or RS-485 connectivity for industrial equipment, data acquisition, or legacy device integration. Plug-and-play installation removes the need for manual I/O address, IRQ, or DMA configuration.
Each port uses a 16C950 UART and provides galvanic isolation plus surge protection for 4-wire RS-422/485 and 2-wire RS-485 wiring. The proprietary ATTA hardware automates RS-485 transceiver turn-around, eliminating software timing overhead and reducing bus contention in multi-drop networks. Drivers install automatically through the standard Install Wizard on supported operating systems.
The card sustains RS-422/485 signalling up to 921.6Kpbs, giving ample bandwidth for most industrial fieldbus and instrumentation tasks. Backward compatibility with the 16-bit PCMCIA R7.1 standard lets it serve older laptops and thin clients alongside newer CardBus platforms. Systems without a PCMCIA or CardBus slot cannot use this adapter, and applications requiring more than two simultaneous serial channels will need additional hardware.
| Model | SG-RS2SIS |
|---|---|
| External Ports | 2 x Serial Ports |
The card uses standard 16C950 UARTs with plug-and-play drivers that install automatically via the Install Wizard; no jumper or I/O address configuration is required, so ongoing maintenance is limited to normal driver updates through the operating system.
Each port is rated for 921.6 Kbps and the CardBus Type-II 32-bit interface provides ample bandwidth, so the serial line speed of 921.6 Kbps per port is the limiting factor under sustained load.
The card draws power directly from the PCMCIA slot and includes isolation and surge protection; with no active cooling or fan, heat output is low and typical of passive serial expansion cards in continuous operation.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Nincs egyező nyelv.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?