Brute Networks
Brute Networks 8GB DDR4 3200 PC4-25600 1Rx8 1.2V Non-ECC UDIMM Dell Compatible
8GB DDR4 3200 UDIMM with 1Rx8 rank and 1.2V operation for Dell servers
- Capacity8GB
- Type288-Pin DDR4 SDRAM
- SpeedDDR4 3200 (PC4 25600)
- Voltage1.20V
- ECCYes
- Buffered/RegisteredUnbuffered
- 8 GB capacity expands server memory headroom
- DDR4 3200 speed accelerates data-intensive workloads
- 2 V operation reduces power draw per module
- 288-pin UDIMM fits standard DDR4 server slots
- major-brand chips ensure Dell-qualified compatibility
8GB DDR4 3200 UDIMM for Dell servers
This 8 GB DDR4 3200 UDIMM is built for Dell PowerEdge systems that accept non-ECC unbuffered memory. It runs at PC4-25600 speed with 1.2 V operation and a 1Rx8 layout. The module uses major-brand DRAM chips and matches Dell part SNPV0M5RC/8G.
Replaces slower DDR4 or fills empty slots
Use this module to replace lower-speed DDR4 DIMMs or to populate vacant slots in a compatible Dell server. The jump is worthwhile when the platform supports 3200 MT/s and the workload benefits from the higher data rate. Do not mix with registered or ECC DIMMs.
Check slot count and memory mode before ordering
Verify that your server has free 288-pin UDIMM slots and that the memory controller is configured for unbuffered non-ECC operation. Confirm the maximum supported capacity per slot and the total system limit in the service manual. Ensure the BIOS is current for 3200 MT/s support.
Privalumai
- 8 GB capacity expands server memory headroom
- DDR4 3200 speed accelerates data-intensive workloads
- 2 V operation reduces power draw per module
- 288-pin UDIMM fits standard DDR4 server slots
- major-brand chips ensure Dell-qualified compatibility
Specifikacijos
| Brand | Dell |
|---|---|
| Capacity | 8GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 3200 (PC4 25600) |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Rank | 1Rx8 |
| Chipset | Major Brand Chipset |
Klausimai apie šią prekę
Will the 288-pin DDR4 UDIMM fit my Dell server's memory slots?
Yes, the module uses the standard 288-pin DDR4 UDIMM form factor designed for Dell servers that accept PC4-25600 memory.
What is the correct way to seat the 1Rx8 module so the server recognises the full 8 GB?
Align the notch with the slot key, press straight down until both side clips click, and verify the 3200 MHz speed in BIOS after boot.
When should I expect to replace this 1.2 V DDR4 module under normal server use?
The module carries a lifetime warranty and uses major-brand chips rated for continuous operation, so replacement is only needed if a fault develops.
Taip pat šiame skyriuje
Kiti pirkėjai taip pat lygino
Ta pati lentyna, tas pats atsiskaitymas — aštuonios monetos ir 30 minučių fiksuotas kursas.



