Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.

Uzraudzītās preces Pieteikties
Green circuit board with eight black memory chips and gold edge connectors

A-Tech

A-Tech Supermicro Certified 8GB DDR4 2400MHz CL17 Desktop RAM

SKU CH-DVMN-D4H14

An 8 GB DDR4 2400 MHz CL17 unbuffered DIMM with Micron chips, certified for Supermicro systems

  • Capacity8GB
  • SpeedDDR4 2400 (PC4 19200)
  • Tested Frequency2400
  • CAS LatencyCL17
  • Voltage1.20V
  • ECCNo
  • Supermicro certified for guaranteed compatibility with approved systems
  • Micron chipset delivers dependable 8 GB DDR4 performance
  • 2400 MHz speed with CL17 latency supports responsive multitasking
  • 20 V standard voltage keeps power draw efficient
  • 288-pin unbuffered DIMM fits standard desktop memory slots

8GB DDR4 2400MHz Desktop Module

This 8GB DDR4 module runs at 2400MHz with CL17 latency and 1.2V operation. It is a non-ECC unbuffered DIMM built on Micron chips and validated for Supermicro systems. The single-rank 1Rx8 design fits standard 288-pin desktop slots. It targets users who need a straightforward capacity increase for compatible platforms.

Installing the 288-Pin DIMM

Installation follows the usual desktop DIMM procedure: power down, open the case, align the notch with the slot key, and press firmly until the retention clips engage. Because the module has no heat spreader, it sits low in the slot and clears most CPU coolers. The main risk is mixing this non-ECC stick with registered or ECC memory, which will prevent the system from posting.

Check Your System Before Ordering

Verify that your motherboard supports DDR4 2400 non-ECC unbuffered memory and has a free 288-pin DIMM slot. Confirm the maximum supported capacity per slot and the total system limit in the board manual. Ensure the BIOS is current enough to recognise the 1Rx8 density. Supermicro certification means it is tested on listed platforms, but other boards require manual compatibility checks.

Priekšrocības

  • Supermicro certified for guaranteed compatibility with approved systems
  • Micron chipset delivers dependable 8 GB DDR4 performance
  • 2400 MHz speed with CL17 latency supports responsive multitasking
  • 20 V standard voltage keeps power draw efficient
  • 288-pin unbuffered DIMM fits standard desktop memory slots

Specifikācijas

BrandSuperMicro
SeriesSupermicro Certified
ModelMEM-DR480L-CL01-UN24
Capacity8GB
SpeedDDR4 2400 (PC4 19200)
Tested Frequency2400
CAS LatencyCL17
Voltage1.20V
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMicron Chipset
Heat SpreaderNo
FeaturesSupermicro Certified MEM-DR480L-CL01-UN24 (Micron)
Recommend UseCompatible Supermicro Systems

Jautājumi par šo preci

Will this module fit a standard desktop motherboard with DDR4 DIMM slots?

Yes, it uses the 288-pin DDR4 DIMM form factor that fits any desktop board with DDR4 slots.

Can I mix this 2400 MHz CL17 stick with faster DDR4 modules already in my system?

The system will run all modules at the speed of the slowest stick, so this 2400 MHz module will set the pace.

Does the non-ECC unbuffered design work in a typical consumer desktop?

Yes, non-ECC unbuffered DDR4 is the standard memory type for consumer desktop platforms.

Arī šajā sadaļā

Klienti arī salīdzināja

Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.