Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.

Uzraudzītās preces Pieteikties
Two green 204-pin DDR3 SODIMM modules side by side

Computer Memory Solutions

Computer Memory Solutions CM5126410600SODRH 8GB DDR3 1333MHz SODIMM for Dell Inspiron 15 N5030 memory upgrade

SKU CH-SGK7-41FG8

8GB dual-channel kit of DDR3 1333MHz SODIMM memory for Dell Inspiron 15 N5030 notebooks

  • Capacity8GB (2 x 4GB)
  • Type204-Pin DDR3 SO-DIMM
  • SpeedDDR3 1333 (PC3 10600)
  • CAS LatencyCL7
  • Timing7-7-7
  • Voltage1.5V
  • 8GB dual-channel kit upgrades Dell Inspiron 15 N5030 to maximum supported memory
  • 1333 MHz DDR3 speed matches factory specification for stable notebook operation
  • CL7 7-7-7 timing delivers low latency response for everyday workloads
  • 5 V unbuffered modules install directly without BIOS changes or extra cooling
  • Two 4 GB sticks fill both slots for full 8 GB capacity

8GB DDR3 Kit for Dell Inspiron 15 N5030

This 8GB kit contains two 4GB DDR3 SO-DIMM modules built for the Dell Inspiron 15 N5030 notebook. It targets owners of that specific laptop who want to reach the system's maximum supported memory of 8GB. The matched pair enables dual-channel operation on the platform's two memory slots.

Unbuffered Non-ECC Modules at 1.5V

Each stick uses a 204-pin SO-DIMM form factor with major-brand chips in a 2Rx8 configuration. The modules run at 1.5V with CL7 7-7-7 timings and have no heat spreader. The low-profile design fits the tight clearance inside the N5030 chassis and installs directly into the two available SODIMM sockets without adapters.

DDR3 1333MHz Speed Ceiling

The kit operates at DDR3 1333 (PC3-10600), which is the fastest speed the N5030 memory controller supports. Faster DDR3 modules will downclock to this rate, so no extra bandwidth is gained. The 8GB total capacity matches the platform limit, leaving no room for further expansion beyond this kit.

Priekšrocības

  • 8GB dual-channel kit upgrades Dell Inspiron 15 N5030 to maximum supported memory
  • 1333 MHz DDR3 speed matches factory specification for stable notebook operation
  • CL7 7-7-7 timing delivers low latency response for everyday workloads
  • 5 V unbuffered modules install directly without BIOS changes or extra cooling
  • Two 4 GB sticks fill both slots for full 8 GB capacity

Specifikācijas

BrandComputer Memory Solutions
ModelCM5126410600SODRH
Capacity8GB (2 x 4GB)
Type204-Pin DDR3 SO-DIMM
SpeedDDR3 1333 (PC3 10600)
CAS LatencyCL7
Timing7-7-7
Voltage1.5V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemDell Inspiron 15 N5030 Notebooks
Package Content2 Memory RAM Sticks

Jautājumi par šo preci

Does the PC3-10600 DDR3 1333MHz interface limit the speed when installed in a Dell Inspiron 15 N5030?

The modules run at DDR3 1333MHz (PC3-10600) with CL7 timing; the notebook's memory controller will operate them at that rated speed.

Will the 204-pin SODIMM form factor fit the two memory slots in the Dell Inspiron 15 N5030?

Yes, each 4GB stick is a standard 204-pin DDR3 SO-DIMM and the system has two sockets supporting up to 8GB total.

What is the correct installation order for the two 4GB sticks, and what step do people often miss?

Power off, remove the battery, open the memory door, insert both modules at an angle until the clips snap; the common mistake is not pressing firmly enough to engage the retention clips.

Arī šajā sadaļā

Klienti arī salīdzināja

Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.