Corsair
Corsair MP600 CORE XT 1TB M.2 2280 NVMe internal SSD
A PCIe Gen4 NVMe drive with up to 5,900 MB/sec read and 5,000 MB/sec write speeds in a compact M.2 2280 form factor
- Device TypeNVME
- PCIe Gen4 x4 controller delivers up to 5,900MB/sec sequential read
- 5,000MB/sec sequential write speeds accelerate load times
- 3D QLC NAND balances performance and value
- M.2 2280 form factor fits notebooks and motherboards
- NVMe 1.4 interface maximises bandwidth for faster response
Capacity and interface
The Corsair MP600 CORE XT is a 1TB internal SSD that uses an M.2 2280 form factor and a PCIe Gen4 x4 NVMe 1.4 interface. It is built for notebook and desktop users who want faster boot times, quicker game loads and snappier file transfers on platforms that support PCIe Gen4 CPUs.
Sustained workload behaviour
High-density 3D QLC NAND provides a balance of performance and value, while the PCIe Gen4 x4 controller delivers up to 5,900MB/sec sequential read and 5,000MB/sec sequential write speeds. Performance and endurance vary by capacity, so extended heavy writes will settle at lower throughput than the peak burst figures.
Compatibility checklist
Verify that your motherboard or laptop has an M.2 slot wired for PCIe Gen4 x4 NVMe 1.4 operation and that the CPU provides Gen4 lanes. The 2280 length must fit the available slot spacing, and the system BIOS should recognise NVMe boot devices for OS installation.
Priekšrocības
- PCIe Gen4 x4 controller delivers up to 5,900MB/sec sequential read
- 5,000MB/sec sequential write speeds accelerate load times
- 3D QLC NAND balances performance and value
- M.2 2280 form factor fits notebooks and motherboards
- NVMe 1.4 interface maximises bandwidth for faster response
Specifikācijas
| Device Type | NVME |
|---|
Jautājumi par šo preci
How much power does the 1TB MP600 CORE XT draw when running continuously?
The drive uses a PCIe Gen4 x4 NVMe 1.4 interface with high-density 3D QLC NAND, designed for efficient operation in laptops and desktops without active cooling.
What must my motherboard provide for this M.2 2280 NVMe drive to work?
Your motherboard needs an M.2 2280 slot wired for PCIe Gen4 x4 and NVMe 1.4 support, plus a CPU that enables PCIe Gen4 lanes.
Will this Gen4 NVMe SSD run at full speed in a PCIe Gen3 M.2 slot?
It will operate in a Gen3 slot but sequential read and write speeds will be limited to the Gen3 bandwidth ceiling.
Arī šajā sadaļā
Klienti arī salīdzināja
Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.
