Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.

Uzraudzītās preces Pieteikties
Silver rectangular ATX power supply unit with fan grille and label

KHACHIMO

KHACHIMO Industrial Control Power Supply 350W ATX FSP300-60GHC(85) FSP300-60PN1

SKU CH-4G2R-HZY63

ATX power supply rated at 350 watts for industrial control systems

  • TypeATX
  • Tested and confirmed working for reliable operation
  • Good-quality components support stable power delivery
  • ATX form factor fits standard industrial chassis
  • 350 W output powers demanding control systems

Industrial ATX Power Supply 350W

This ATX form-factor power supply delivers 350 watts of continuous power for industrial control systems. It is built to replace units such as the GTP-3500L and ST-350PFC in embedded or automation chassis. The unit ships new and has been tested for reliable operation.

Direct replacement for FSP300-60GHC and FSP300-60PN1

The supply matches the electrical and mechanical profile of the FSP300-60GHC(85) and FSP300-60PN1 models used in legacy industrial platforms. It is the correct choice when a drop-in 350 W ATX unit is required to restore power to those specific systems. It is not suited for builds needing higher wattage or redundant hot-swap modules.

Priekšrocības

  • Tested and confirmed working for reliable operation
  • Good-quality components support stable power delivery
  • ATX form factor fits standard industrial chassis
  • 350 W output powers demanding control systems

Specifikācijas

TypeATX

Jautājumi par šo preci

Will this ATX power supply fit the standard mounting holes in my industrial chassis?

The unit follows the ATX form factor so it uses the standard four-hole mounting pattern found on industrial chassis designed for ATX supplies.

What is the correct way to connect the main power cable to the motherboard, and what mistake should I avoid?

Seat the 24-pin ATX connector fully until the latch clicks; the common error is leaving it partially inserted which causes intermittent power.

Arī šajā sadaļā

Klienti arī salīdzināja

Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.