SanDisk
SanDisk Cruzer Blade 8 GB USB 2.0 USB flash drive Black SDCZ50-008G-B35
391,99 $
0.00506866BTC
Krājumā
Kingston Technology Corp.
Kingston Technology Corp. KVR16LS11/8 8GB DDR3L 1600 laptop RAM
8GB DDR3L 1600 SO-DIMM laptop memory running at 1.35V with CL11 latency
- Capacity8GB
- Type204-Pin DDR3 SO-DIMM
- SpeedDDR3L 1600 (PC3L 12800)
- CAS LatencyCL11
- Voltage1.35V
- ECCNo
- 8 GB capacity expands multitasking headroom for demanding workloads
- DDR3L 1600 speed delivers 1600 Mb/s data rates
- Low 1.35 V operation reduces power draw and heat
- CL11 latency supports responsive memory access timing
- 204-pin SO-DIMM form factor fits standard laptop slots
Capacity and speed
This Kingston KVR16LS11/8 module provides 8 GB of DDR3L memory running at 1600 MHz with a CAS latency of 11. It uses the 204-pin SO-DIMM form factor standard for laptops and operates at the JEDEC low voltage of 1.35 V.
Who this suits and who it does not
The stick fits any notebook that accepts unbuffered, non-ECC DDR3L SO-DIMMs at this speed and voltage. Systems that require registered memory, ECC error correction, standard 1.5 V DDR3 only, or a different pin count cannot use this module.
Deciding specification
The critical figure is the 1.35 V DDR3L rating combined with 1600 MHz speed; the laptop’s memory controller must support this exact voltage and frequency pair for the module to function correctly.
Priekšrocības
- 8 GB capacity expands multitasking headroom for demanding workloads
- DDR3L 1600 speed delivers 1600 Mb/s data rates
- Low 1.35 V operation reduces power draw and heat
- CL11 latency supports responsive memory access timing
- 204-pin SO-DIMM form factor fits standard laptop slots
Specifikācijas
| Brand | Kingston |
|---|---|
| Model | KVR16LS11/8 |
| Capacity | 8GB |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Features | JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) Power SupplyVDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)800 MHz fCK for 1600 Mb/sec/pin8 independent internal banksProgrammable CAS Latency: 11, 10, 9, 8, 7, 6Programmable Additive Latency: 0, CL-2, or CL-1 clock8-bit pre-fetchBurst Length: 8 (Interleave without any limit, sequential with starting address "000" only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]Bi-directional Differential Data StrobeInternal(self) calibration: Internal self calibration throug |
Jautājumi par šo preci
Will the 204-pin SO-DIMM fit my laptop's DDR3L slot?
The module uses the standard 204-pin SO-DIMM form factor for DDR3L, matching laptop slots built to that specification.
Do I need to change any BIOS settings when installing this 1.35V DDR3L module?
Most laptops detect the 1.35V JEDEC profile automatically; the common mistake is leaving an old 1.5V module in the second slot, which can force the system to run at the higher voltage.
Does this unbuffered non-ECC stick require any firmware updates or periodic maintenance?
No firmware updates or scheduled maintenance are needed; the memory is a passive component that either works or is replaced if it fails.
Arī šajā sadaļā
Klienti arī salīdzināja
Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.
