SanDisk
SanDisk Cruzer Blade 8 GB USB 2.0 USB flash drive Black SDCZ50-008G-B35
$391,99
0.005031BTC
Stokta
Computer Memory Solutions
Computer Memory Solutions CM1024722400ECCR 32GB DDR4 2400 ECC Registered
A 32 GB registered ECC DDR4 kit of four 8 GB modules at 2400 MHz CL17, validated for ASUS ESC4000 G3, G3S, G4 and G4X servers
- Capacity32GB (4 x 8GB)
- Type288-Pin DDR4 SDRAM
- SpeedDDR4 2400 (PC4 19200)
- CAS LatencyCL17
- Timing17-17-17
- Voltage1.2V
- 32 GB capacity across four 8 GB modules for high-density server memory
- ECC registered DIMMs detect and correct single-bit errors to protect data integrity
- DDR4 2400 MHz speed with CL17 timing delivers responsive throughput for compatible ASUS servers
- 288-pin 1.2 V design matches DDR4 server slot requirements for reliable installation
- Guaranteed compatibility with ASUS ESC4000 G3, G3S, G4 and G4X server platforms
Purpose-built server memory
This 32 GB kit contains four 8 GB DDR4 registered DIMMs validated for ASUS ESC4000 G3, G3S, G4 and G4X servers. ECC and registered buffering protect data integrity in multi-socket environments where uptime is critical. The modules run at 1.2 V and conform to the 288-pin DDR4 form factor required by these platforms.
Sustained-load behaviour
Registered signalling reduces electrical load on the memory controller, allowing all 16 DIMM slots per dual-CPU node to remain populated without signal degradation. CL17 17-17-17 timing delivers consistent latency during long compute runs rather than brief benchmark bursts. The kit operates at the rated 2400 MT/s when the installed processors support that frequency.
Deciding specification
Registered ECC DDR4 is mandatory for the target servers; unbuffered or non-ECC modules will not function in these boards. The four-stick, 32 GB configuration fits the 8-socket-per-CPU limit and leaves room to scale toward the 512 GB RDIMM maximum. Buyers needing unbuffered memory or consumer form factors should look elsewhere.
Öne çıkanlar
- 32 GB capacity across four 8 GB modules for high-density server memory
- ECC registered DIMMs detect and correct single-bit errors to protect data integrity
- DDR4 2400 MHz speed with CL17 timing delivers responsive throughput for compatible ASUS servers
- 288-pin 1.2 V design matches DDR4 server slot requirements for reliable installation
- Guaranteed compatibility with ASUS ESC4000 G3, G3S, G4 and G4X server platforms
Teknik özellikler
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM1024722400ECCR |
| Capacity | 32GB (4 x 8GB) |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Timing | 17-17-17 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | ASUS/ASmobile ESC4000 G3 Server (Z10PG-D16), G3S Server (Z10PG-D16), G4 Server, G4X Server |
| Package Content | 4 Memory RAM Sticks |
Bu ürünle ilgili sorular
How much power does the 1.2V DDR4 2400 kit draw when the server runs continuously?
Each module operates at 1.2 volts, the standard DDR4 voltage, so total power scales with the four 8 GB sticks installed.
What must the chassis provide for these 288-pin registered DIMMs to function?
A motherboard with 288-pin DDR4 slots that accepts registered ECC memory and a CPU memory controller supporting RDIMMs.
Will the CL17 2400 MHz sticks run at rated speed in an older ESC4000 G3 with a different processor?
Memory will clock down to run at optimal speeds depending on the processor model installed.
Bu reyondan diğerleri
Müşteriler bunları karşılaştırdı
Aynı raf, aynı sipariş tamamlama — sekiz koin ve 30 dakikalık kur kilidi.
