DELL
DELL 400-ANUT 4 TB 3.5" Internal Hard Drive SAS 12Gb/s 7200 RPM
A 4 TB 3.5" internal hard drive with 7200 RPM spindle speed and hot-swappable SAS 12Gb/s interface for Dell PowerEdge servers
- InterfaceSAS 12Gb/s
- Capacity4TB
- Form Factor3.5"
- 4 TB capacity expands server storage
- 7200 RPM spindle speed accelerates data access
- SAS 12Gb/s interface enables high-throughput transfers
- Hot-swappable 3.5" form factor simplifies drive replacement
- Compatible with Dell PowerEdge R230 R330 R430 R530 R730 R730XD T330 T430 T630
4 TB SAS Hard Drive for Dell Servers
This 4 TB internal hard drive uses a Near Line SAS interface running at 12Gb/s and spins at 7200 RPM. It is built for Dell PowerEdge servers including the R230, R330, R430, R530, R730, R730XD, T330, T430 and T630. The drive adds high-capacity storage to compatible systems.
Hot-Swap 3.5 Inch Form Factor
The 3.5 inch form factor fits standard server drive bays and supports both hot-swap and hot-plug operation. This allows drive replacement or expansion without powering down the server. The SAS connector provides a secure, enterprise-grade link for continuous workloads.
12Gb/s SAS Interface Limits
The 12Gb/s SAS interface sets the maximum bus transfer rate, while the 7200 RPM spindle speed governs sustained throughput and latency. Performance will vary with controller, RAID level and workload mix. Buyers needing higher random IOPS or lower latency should consider solid-state alternatives.
Öne çıkanlar
- 4 TB capacity expands server storage
- 7200 RPM spindle speed accelerates data access
- SAS 12Gb/s interface enables high-throughput transfers
- Hot-swappable 3.5" form factor simplifies drive replacement
- Compatible with Dell PowerEdge R230 R330 R430 R530 R730 R730XD T330 T430 T630
Teknik özellikler
| Brand | Dell |
|---|---|
| Interface | SAS 12Gb/s |
| Capacity | 4TB |
| Form Factor | 3.5" |
Bu ürünle ilgili sorular
What throughput does the 12Gb/s SAS interface actually cap at?
The 12Gb/s SAS interface limits the drive to a maximum of 12 gigabits per second, though real-world speed depends on the controller and workload.
Does the 3.5" form factor need a specific bay or carrier to fit?
It fits a standard 3.5-inch internal bay; hot-swap servers such as the PowerEdge R730 require the Dell drive carrier for tool-less insertion.
How is the drive installed in a hot-swap chassis, and what step is often missed?
Slide the carrier into the bay until the latch clicks, then verify the SAS and power connectors are fully seated; forgetting to lock the carrier handle is the common error.
Bu reyondan diğerleri
Müşteriler bunları karşılaştırdı
Aynı raf, aynı sipariş tamamlama — sekiz koin ve 30 dakikalık kur kilidi.
