DELL
DELL X160K-CO2 146GB 10000 RPM 2.5" SAS internal hard drive
A 2.5" SAS drive spinning at 10000 RPM with 146GB capacity for server workloads
- InterfaceSerial Attached SCSI (SAS)
- Capacity146GB
- RPM10000 RPM
- UsageIdeal for Servers
- Form Factor2.5"
- Fast data access from 10000 RPM spindle speed
- 146 GB capacity suits server storage needs
- 5 inch form factor fits dense drive bays
- SAS interface provides reliable server connectivity
- New condition ensures full manufacturer specifications
Dell 146GB 10K SAS drive
The Dell X160K-CO2 is a 146GB 2.5-inch internal hard drive spinning at 10000 RPM. It uses a Serial Attached SCSI (SAS) interface for direct connection to compatible server backplanes. The drive is supplied new and tested with updated firmware. It is designed for deployment in enterprise server environments.
Suits servers needing 146GB SAS.
This drive suits administrators refreshing or expanding storage arrays that specifically require 146GB SAS units at 10000 RPM. It fits hot-swap bays designed for 2.5-inch SAS form factors. Buyers who need more storage capacity per drive should look at higher-capacity models. Systems lacking a SAS controller or backplane cannot use this drive.
146GB capacity decides fit
The single specification that decides suitability is the 146GB capacity. A server slot or array rebuild requiring exactly this capacity will accept the drive. Any requirement for a different total capacity makes this model the wrong part regardless of its speed or interface.
Öne çıkanlar
- Fast data access from 10000 RPM spindle speed
- 146 GB capacity suits server storage needs
- 5 inch form factor fits dense drive bays
- SAS interface provides reliable server connectivity
- New condition ensures full manufacturer specifications
Teknik özellikler
| Brand | Dell |
|---|---|
| Model | X160K |
| Interface | Serial Attached SCSI (SAS) |
| Capacity | 146GB |
| RPM | 10000 RPM |
| Usage | Ideal for Servers |
| Form Factor | 2.5" |
Bu ürünle ilgili sorular
Does the 2.5" SAS drive fit a standard 2.5" hot-swap bay?
The 2.5" form factor matches standard 2.5" SAS hot-swap bays used in Dell PowerEdge servers; verify the tray or caddy matches your chassis.
What is the common mistake when installing the X160K-CO2 in a SAS backplane?
Inserting the drive before the backplane is fully seated or neglecting the SAS connector alignment pin causes detection failures; press firmly until the latch clicks.
When should the 146GB 10000 RPM SAS drive be replaced in a RAID array?
Replace the drive when SMART reallocated sectors rise above the vendor threshold or after a predictive failure alert during routine array scrubbing.
Bu reyondan diğerleri
Müşteriler bunları karşılaştırdı
Aynı raf, aynı sipariş tamamlama — sekiz koin ve 30 dakikalık kur kilidi.
