SanDisk
SanDisk Cruzer Blade 8 GB USB 2.0 USB flash drive Black SDCZ50-008G-B35
$391,99
0.00502069BTC
Stokta
LORDWORLD
LORDWORLD SX1262 LoRa HAT 915MHz development board
LoRa HAT for Raspberry Pi boards operating at 915 MHz with up to 5 km range
- Up to 5 km range with SX1262 LoRa modulation
- 915 MHz band for America, Oceania and Asia
- Compatible with Raspberry Pi 4, 3, 2 and 1 series
- Wake on Radio plus wireless configuration support
- Carrier sensing and communication key for secure links
LoRa HAT for Raspberry Pi Series
This LORDWORLD SX1262 LoRa HAT mounts on Raspberry Pi 4, 3, 2 and 1 series boards and operates on the 915MHz band for regions including America, Oceania and Asia. It is built for makers and engineers developing long-range IoT edge devices. The board uses the SX1262 transceiver to send data up to 5km via serial port and supports auto-repeating for extended reach.
40-pin HAT form factor with serial link
The HAT connects through the standard 40-pin GPIO header and communicates with the host over a serial interface, so no extra wiring or adapters are required. Features such as Wake on Radio, wireless configuration, carrier sensing and a communication key are handled on-board, reducing host CPU load and simplifying power management in remote deployments.
Check 915MHz band clearance and serial access
Before ordering, verify that 915MHz ISM-band use is permitted at your installation site and that your Raspberry Pi OS exposes a free serial port for the module. Projects needing a different regional band or a non-serial host interface will not be compatible with this board.
Öne çıkanlar
- Up to 5 km range with SX1262 LoRa modulation
- 915 MHz band for America, Oceania and Asia
- Compatible with Raspberry Pi 4, 3, 2 and 1 series
- Wake on Radio plus wireless configuration support
- Carrier sensing and communication key for secure links
Teknik özellikler
| Brand | LORDWORLD |
|---|
Bu ürünle ilgili sorular
Does the 915MHz SX1262 LoRa HAT communicate with the Raspberry Pi over a serial port?
Yes, the board connects to the Raspberry Pi via a serial port for data transmission up to 5km.
Which Raspberry Pi models does this HAT physically fit on?
It is designed for Raspberry Pi 4, 3, 2 and 1 series boards using the standard 40-pin GPIO header.
How is the HAT installed on the Raspberry Pi and what step is often missed?
Align the HAT with the 40-pin GPIO header, press firmly to seat all pins, then enable the serial port in raspi-config before use.
Bu reyondan diğerleri
Müşteriler bunları karşılaştırdı
Aynı raf, aynı sipariş tamamlama — sekiz koin ve 30 dakikalık kur kilidi.
