Kripto para kabul ediyoruz — böylece elinizdeki koinlerle gerçek donanım alabilirsiniz.Kripto parayla ödeyin, onu gerçek donanıma harcayın. $399 üzeri siparişlerde dünya genelinde sigortalı kargo ücretsizdir. Sade, markasız koliler Almanya’dan gönderilir.$399 üzeri siparişlerde sigortalı kargo ücretsizdir. Ödeme sayfası açıldığında kurunuz 30 dakika kilitli kalır.Kur 30 dakika kilitli. Her ürün mühürlüdür, seri numarası kontrol edilir ve 24 ay garanti kapsamındadır.Mühürlü, 24 ay garantili.

Favori ürünler Giriş yap

NEMIX RAM

NEMIX RAM 48GB DDR5 5600 CL46 2Rx8 1.1V UDIMM Supermicro X14SAZ-TLN4F memory upgrade

SKU CH-3MKG-0V46G

48 GB DDR5 5600 CL46 2Rx8 UDIMM built with major OEM chips and validated for the Supermicro X14SAZ-TLN4F motherboard

  • Capacity48GB
  • Type288-Pin DDR5 UDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCNo
  • 48 GB capacity for demanding workloads using a single 48GB module
  • DDR5 5600 speed transfers data at PC5-44800 bandwidth
  • CL46 CAS latency matches the memory controller timing for stable operation
  • 1 V low voltage reduces power draw and heat output
  • 2Rx8 dual-rank organisation maximises density on a 288-pin UDIMM

Exact DDR5-5600 upgrade for Supermicro X14SAZ-TLN4F

This 48GB NEMIX RAM module is a system-specific UDIMM built to match the Supermicro X14SAZ-TLN4F motherboard. It uses the 288-pin DDR5 form factor required by that board. The kit contains a single 48GB stick rated at PC5-44800 speed.

CL46 timing at 1.1V decides compatibility

The memory controller expects a CAS latency of 46 cycles at 1.10V with a 2Rx8 rank structure. These exact figures allow the module to be recognised at full capacity and run at its rated 5600MT/s data rate without manual tuning. Any deviation in timing, voltage or rank would prevent correct operation.

Major OEM chips sustain rated speed under load

Samsung, Micron or Hynix ICs are tested for stability at the specified 5600MT/s, CL46 and 1.1V during extended operation. The unbuffered design feeds data directly to the controller without added latency. Systems needing ECC registered modules or SODIMM form factors cannot use this kit.

Öne çıkanlar

  • 48 GB capacity for demanding workloads using a single 48GB module
  • DDR5 5600 speed transfers data at PC5-44800 bandwidth
  • CL46 CAS latency matches the memory controller timing for stable operation
  • 1 V low voltage reduces power draw and heat output
  • 2Rx8 dual-rank organisation maximises density on a 288-pin UDIMM

Teknik özellikler

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 Non-ECC Unbuffered UDIMM Memory
Part NumberMD44800-4828K1
Capacity48GB
Type288-Pin DDR5 UDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 Non-ECC Unbuffered UDIMM Motherboard Compatible
Package Content48GB DDR5 5600MHz PC5-44800 2Rx8 1.1V 288-PIN Non-ECC UDIMM KIT

Bu modelin diğer sürümleri

Aynı seriden 5 tane daha

Aynı aile, farklı bellek, soğutucu veya frekans — karar vermeden önce karşılaştırın.

Bu ürünle ilgili sorular

Will 5600 MT/s actually run at that speed in my Supermicro X14SAZ-TLN4F?

The module is spec-matched to the board's memory controller, so it initializes at DDR5 5600 (PC5-44800) with CL46 timing at 1.1 V without manual tuning.

Is the 288-pin DDR5 interface electrically compatible with the Supermicro X14SAZ-TLN4F slots?

Yes, the 288-pin UDIMM form factor matches the unbuffered non-ECC DDR5 slots on that motherboard; the 2Rx8 rank structure is what the board's population rules expect.

Does the 48 GB kit need a heat spreader or extra clearance in a standard desktop chassis?

No heat spreader is fitted, so the bare 288-pin PCB fits within normal DIMM keep-out zones and works with standard CPU coolers.

Bu reyondan diğerleri

Müşteriler bunları karşılaştırdı

Aynı raf, aynı sipariş tamamlama — sekiz koin ve 30 dakikalık kur kilidi.