OWC
OWC 4GB DDR3 1600 PC3-12800 CL11 2Rx8 240-pin 1.5V ECC Unbuffered UDIMM Memory Upgrade
4 GB DDR3-1600 ECC UDIMM module for QNAP SS-EC and TS-EC series NAS units
- Capacity4GB
- Type240-Pin DDR3 ECC UDIMM
- SpeedDDR3 1600 (PC3 12800)
- CAS LatencyCL11
- Voltage1.5V
- ECCYes
- 4GB capacity expands system memory for multitasking
- DDR3 1600 speed with CL11 latency delivers responsive performance
- ECC unbuffered design protects data integrity in servers
- 240-pin UDIMM fits QNAP SS-EC and TS-EC series
- JEDEC and RoHS compliant for warranty-safe upgrades
QNAP NAS Memory Upgrade
This 4GB DDR3 1600 module is built for QNAP SS-EC and TS-EC SAS rackmount units. It adds ECC protection to compatible storage servers that need data integrity for critical workloads. The unbuffered design fits the specific memory slots on the listed models. Buyers who need higher capacities or registered DIMMs cannot use this module.
240-Pin DIMM Installation
The stick inserts into a standard 240-pin DDR3 slot on the system board. No heat spreader means the module sits low, but adjacent components can still block access in dense chassis. Alignment notches prevent backward insertion, yet forcing the latch risks cracking the PCB. Systems that require matched pairs or specific population rules will not accept a single stick.
Sustained ECC Operation
ECC circuitry corrects single-bit errors continuously during long file transfers or RAID rebuilds. The 1.5V rating keeps power draw steady under constant load without thermal throttling. JEDEC CL11 timing maintains stability when the memory controller runs at full speed for hours. Workloads that exceed 4GB capacity will swap to disk, negating the speed advantage.
Öne çıkanlar
- 4GB capacity expands system memory for multitasking
- DDR3 1600 speed with CL11 latency delivers responsive performance
- ECC unbuffered design protects data integrity in servers
- 240-pin UDIMM fits QNAP SS-EC and TS-EC series
- JEDEC and RoHS compliant for warranty-safe upgrades
Teknik özellikler
| Brand | OWC |
|---|---|
| Part Number | 1E6D32R804GB |
| Capacity | 4GB |
| Type | 240-Pin DDR3 ECC UDIMM |
| Speed | DDR3 1600 (PC3 12800) |
| CAS Latency | CL11 |
| Voltage | 1.5V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | QNAP SS-EC1279U-SAS-RP QNAP SS-EC1679U-SAS-RP QNAP SS-EC1879U-SAS-RP QNAP SS-EC2479U-SAS-RP QNAP TS-EC1279U-SAS-RP |
Bu modelin diğer sürümleri
Aynı seriden 5 tane daha
Aynı aile, farklı bellek, soğutucu veya frekans — karar vermeden önce karşılaştırın.
OWC 1U6D31R804GB 4GB DDR3 1600 CL11 1.5V 240-pin UDIMM for ThinkStation P300
- 4GB
- 240-Pin DDR3 Non-EC…
OWC 4GB DDR3 1600 CL11 1Rx8 204-pin 1.5V Non-ECC SODIMM memory upgrade
- 4GB
- 204-Pin DDR3 Non-EC…
OWC 4GB DDR3 1600 PC3-12800 CL11 2Rx8 204-pin 1.5V Non-ECC SODIMM for QNAP IS-400 Pro TVS-471 TVS-671 TVS-871
- 4GB
- 204-Pin DDR3 Non-EC…
OWC 4GB DDR3 1600 PC3-12800 CL11 1Rx8 240-pin 1.5V Non-ECC UDIMM memory upgrade
- 4GB
- 240-Pin DDR3 Non-EC…
Bu ürünle ilgili sorular
How can I verify the 4GB DDR3 1600 module is running at CL11 1.5V after installing it in my QNAP SS-EC1279U-SAS-RP?
Enter the NAS BIOS or use the QNAP system information page; it will show the detected speed as PC3-12800, CAS latency 11 and voltage 1.5V for the new DIMM.
What ships with the OWC 1E6D32R804GB module and what must I source separately?
The box contains the single 4GB 240-pin ECC UDIMM only; no tools, screws or additional memory sticks are included.
Which capacity should I choose if my TS-EC1279U-SAS-RP has four empty slots and supports up to 32GB total?
Populate each slot with a 4GB module to reach the 32GB maximum; mixing different capacities is not required.
Bu reyondan diğerleri
Müşteriler bunları karşılaştırdı
Aynı raf, aynı sipariş tamamlama — sekiz koin ve 30 dakikalık kur kilidi.








