Two green DDR2 DIMM sticks with gold edge connectors

Computer Memory Solutions

Computer Memory Solutions 16GB (2x8GB) DDR2 667MHz ECC Registered DIMM memory upgrade

SKU CH-KTVC-EJY0D

16 GB kit of two 8 GB DDR2-667 ECC registered DIMMs for Supermicro X7DCL-i and X7DCT servers

Capacity16GB (2 x 8GB)
Type240-Pin DDR2 SDRAM
SpeedDDR2 667 (PC2 5300)
CAS LatencyCL5
Timing5-5-5
Voltage1.8V

ECC protection prevents data corruption in critical server workloads
Registered signal buffering enables stable operation at full 16GB capacity
Dual-channel kit delivers 16GB across matched 8GB modules
Guaranteed compatibility with listed Supermicro X7DCL-i and X7DCT server models
DDR2-667 PC2-5300 speed matches original system specifications

32,99 $

0.00042601 BTC με τη σημερινή ισοτιμία

Διαθέσιμο · αποστολή σήμερα

Το ταμείο κλειδώνει την ισοτιμία σας για 30 λεπτά.

Παράδοση προς Ηνωμένες Πολιτείες εκτίμηση

UPS Worldwide Expedited 3–6 εργάσιμες ημέρες 39,90 $
DHL Express Worldwide 2–3 εργάσιμες ημέρες 74,90 $

Προσθέστε 366,01 $ ακόμη και η βασική αποστολή γίνεται δωρεάν.

Οι εισαγωγικοί δασμοί επιβάλλονται κατά την άφιξη από τη χώρα σας.

Αποστολή αλλού

Targeted server upgrade

This 16GB kit contains two 8GB registered ECC DIMMs built to the DDR2 667MHz PC2-5300 standard. It is designed exclusively for the Supermicro X7DCL-i, X7DCT, X7DCT-10G, X7DCT-3 and X7DCT-3F server platforms listed by the supplier. The modules install in matched pairs to enable dual-channel operation on those boards.

Suited for maintainers of these specific

It suits administrators restoring or expanding memory in the exact models named above. It does not suit systems that take unbuffered DDR2, nor boards that cannot accept registered DIMMs or require single-rank modules. Builders working with any other platform should look elsewhere because compatibility is guaranteed only for the listed part numbers.

Registered ECC DDR2 667MHz

The single specification that decides fit is the registered ECC DDR2 667MHz (PC2-5300) interface in a 240-pin DIMM form factor. The target motherboard must support registered error-correcting modules at this speed and voltage. If the board requires unbuffered memory, a different DDR generation, or a non-ECC configuration, these modules will not work.

Βασικά χαρακτηριστικά

ECC protection prevents data corruption in critical server workloads
Registered signal buffering enables stable operation at full 16GB capacity
Dual-channel kit delivers 16GB across matched 8GB modules
Guaranteed compatibility with listed Supermicro X7DCL-i and X7DCT server models
DDR2-667 PC2-5300 speed matches original system specifications

Προδιαγραφές

Brand	Computer Memory Solutions
Model	CM1024725300ECCREG2R4
Capacity	16GB (2 x 8GB)
Type	240-Pin DDR2 SDRAM
Speed	DDR2 667 (PC2 5300)
CAS Latency	CL5
Timing	5-5-5
Voltage	1.8V
ECC	Yes
Buffered/Registered	Registered
Rank	2Rx4
Chipset	Major Brand Chipset
Heat Spreader	No
Compatible System	Supermicro X7DCL-i X7DCT, X7DCT-10G, X7DCT-3, X7DCT-3F Servers
Package Content	2 Memory RAM Sticks

Ερωτήσεις για αυτό το προϊόν

Does this kit fit the 240-pin DDR2 slots on a Supermicro X7DCL-i server board?

Yes, the modules are 240-pin DDR2 SDRAM DIMMs designed for the X7DCL-i, X7DCT, X7DCT-10G, X7DCT-3 and X7DCT-3F server boards listed in the compatibility data.

What is the correct way to install the two 8 GB sticks so the server runs in dual-channel mode?

Install the pair into the same memory bank — the X7DCL-i has three banks of two sockets each — and always populate both sockets of a bank with identical modules; mixing x4 and x8 chips inside one bank is not supported.

When should the registered ECC DIMMs be replaced if the server starts logging corrected memory errors?

Replace the modules when the system management log shows a rising count of correctable ECC events, indicating the chips are degrading; the kit carries a limited lifetime warranty for exchange when purchased directly from the manufacturer.

Επίσης σε αυτό το ράφι