Small green circuit board with 1.3 inch square colour LCD screen and pin headers

LORDWORLD

LORDWORLD ESP32-S3 1.3inch 240×240 262K LCD Development Board

SKU CH-K908-K6TJX

Compact ESP32-S3 board with 1.3 inch 240×240 262K LCD, 6-axis IMU, battery manager and 90° hardware rotation

Compact 1.3 inch display fits tight enclosures
240×240 pixel 262K colour LCD shows sharp graphics
Dual-core 240 MHz processor handles real-time tasks
Built-in 6-axis IMU adds motion sensing
ST7789V2 driver enables 90° hardware rotation

40,99 $

0.00052501 BTC με τη σημερινή ισοτιμία

Διαθέσιμο · αποστολή σήμερα

Το ταμείο κλειδώνει την ισοτιμία σας για 30 λεπτά.

Παράδοση προς Ηνωμένες Πολιτείες εκτίμηση

UPS Worldwide Expedited 3–6 εργάσιμες ημέρες 39,90 $
DHL Express Worldwide 2–3 εργάσιμες ημέρες 74,90 $

Προσθέστε 358,01 $ ακόμη και η βασική αποστολή γίνεται δωρεάν.

Οι εισαγωγικοί δασμοί επιβάλλονται κατά την άφιξη από τη χώρα σας.

Αποστολή αλλού

Compact IoT Development Board

The LORDWORLD ESP32-S3 board integrates a 1.3inch 262K colour LCD with a 240MHz dual-core processor. Onboard Wi-Fi and Bluetooth connectivity plus a 6-axis IMU suit rapid prototyping of wearable or sensor-driven IoT edge devices.

Low-Power Operation

The compact design draws minimal current during typical sensor and display tasks. Lithium battery recharge management is built in, allowing extended untethered operation without external power circuitry.

Embedded Integration Ready

SPI communication and 90° hardware rotation simplify mounting in tight enclosures. The ST7789V2 driver handles the 240×240 panel directly, freeing the developer from display timing concerns while leaving GPIO available for additional peripherals.

Βασικά χαρακτηριστικά

Compact 1.3 inch display fits tight enclosures
240×240 pixel 262K colour LCD shows sharp graphics
Dual-core 240 MHz processor handles real-time tasks
Built-in 6-axis IMU adds motion sensing
ST7789V2 driver enables 90° hardware rotation

Προδιαγραφές

Brand	LORDWORLD

Ερωτήσεις για αυτό το προϊόν

How do I install the board and which step is often missed?

Connect via USB-C for power and programming, then install the ESP32 board package in Arduino IDE; the step often missed is selecting the correct COM port and ESP32-S3 Dev Module before uploading.

What maintenance or replacement will the board need later?

The onboard lithium battery recharge manager handles the Li-ion cell; over time the battery itself may need replacement if capacity drops below usable levels.

What limit appears first during sustained use?

The 240 MHz dual-core processor can throttle due to heat in the compact 1.3 inch form factor during continuous high-load operation.

Επίσης σε αυτό το ράφι