MCDODO
MCDODO 5 Pack 0.91 Inch OLED 128x32 SSD1306 White Text Development Board
Five 0.91-inch OLED modules with 128x32 SSD1306 drivers, I2C interface and 3.3V-5V operation for multiple microcontroller projects
- TypeSingle Board Computers
- Five displays per pack for multiple projects
- 91 inch 128x32 OLED shows crisp white text
- SSD1306 driver with I2C needs only two data lines
- Works at 3.3V or 5V with ESP32 ESP8266 STM32
- Self-luminous panel uses no backlight saving battery power
Five OLED modules in one pack
This pack supplies five 0.91 inch OLED modules, each with a 128x32 white-text display and an integrated SSD1306 driver. The boards are intended for makers, students and engineers building sensor nodes, status panels or wearable prototypes that need a compact self-illuminating screen.
Low power draw and simple wiring
The self-luminous panels operate without a backlight, which keeps current draw small for battery-powered devices. Communication uses a standard I2C bus needing only two data lines plus power, so the modules add minimal load to a microcontroller's pins and thermal budget.
Replaces bare LCDs or single-module purchases
Builders who previously used character LCDs gain higher contrast and wider viewing angles without extra wiring. The five-unit bundle suits projects that need several identical displays at once, while single-display experiments are better served by individual boards.
Βασικά χαρακτηριστικά
- Five displays per pack for multiple projects
- 91 inch 128x32 OLED shows crisp white text
- SSD1306 driver with I2C needs only two data lines
- Works at 3.3V or 5V with ESP32 ESP8266 STM32
- Self-luminous panel uses no backlight saving battery power
Προδιαγραφές
| Type | Single Board Computers |
|---|
Ερωτήσεις για αυτό το προϊόν
How do I wire the 4-pin I2C interface on the 0.91 inch SSD1306 board and which step causes the display to stay blank?
Connect VCC to 3.3 V or 5 V, GND to ground, SDA to the data line and SCK to the clock line; the common mistake is swapping SDA and SCK, which prevents any communication.
What component will degrade first and require module replacement during long-term use?
The self-illuminating OLED pixels gradually lose brightness; once white text becomes too dim to read, the entire 128x32 module must be replaced.
What is the first limitation that appears when the display runs continuously at 5 V?
The 128x32 pixel array can only show a small amount of text at once, so sustained logging quickly fills the screen and forces scrolling or clearing.
Επίσης σε αυτό το ράφι
Οι πελάτες σύγκριναν και αυτά
Ίδιο ράφι, ίδιο ταμείο — οκτώ νομίσματα και κλείδωμα ισοτιμίας 30 λεπτών.



