Pimoroni

Pimoroni PIM358 Wildlife Camera 32GB development board

SKU CH-QTBD-CRK94

A Raspberry Pi Zero W development kit with a 32 GB microSD card pre-loaded with NOOBS and a camera module for building a wildlife camera

Ready for nature photography with Raspberry Pi Zero W
32GB microSD pre-loaded with NOOBS for instant setup
Camera module included for wildlife capture
USB cable and heatsink supplied for power and cooling

52,99 $

0.00067086 BTC με τη σημερινή ισοτιμία

Διαθέσιμο · αποστολή σήμερα

Το ταμείο κλειδώνει την ισοτιμία σας για 30 λεπτά.

Παράδοση προς Ηνωμένες Πολιτείες εκτίμηση

UPS Worldwide Expedited 3–6 εργάσιμες ημέρες 39,90 $
DHL Express Worldwide 2–3 εργάσιμες ημέρες 74,90 $

Προσθέστε 346,01 $ ακόμη και η βασική αποστολή γίνεται δωρεάν.

Οι εισαγωγικοί δασμοί επιβάλλονται κατά την άφιξη από τη χώρα σας.

Αποστολή αλλού

Wildlife Camera Kit 32GB

This development board kit combines a Raspberry Pi Zero W with a camera module and a 32GB microSD card pre-loaded with NOOBS. It is designed for makers who want to build a Raspberry Pi-powered wildlife camera in collaboration with My Naturewatch. The package includes a USB A to micro B cable and a heatsink for thermal management during operation.

Beginner-Friendly Assembly

The kit arrives with all essential components in one box, so soldering is not required to start the build. Users insert the pre-loaded microSD card, connect the camera module via the board's ribbon connector, and attach the heatsink to the processor. A common issue is loose ribbon-cable seating, which causes the camera to go undetected on first boot.

Βασικά χαρακτηριστικά

Ready for nature photography with Raspberry Pi Zero W
32GB microSD pre-loaded with NOOBS for instant setup
Camera module included for wildlife capture
USB cable and heatsink supplied for power and cooling

Προδιαγραφές

Δεν έχουν δημοσιευτεί ακόμη προδιαγραφές για αυτό το προϊόν.

Ερωτήσεις για αυτό το προϊόν

How do I confirm the wildlife camera is recording properly after assembly?

Power the board, let the motion detection trigger a capture, then remove the 32GB microSD card and review the saved images on another device.

What components are included and what must I source separately?

The kit supplies a Raspberry Pi Zero W, a camera module, a 32GB microSD card pre-loaded with NOOBS plus an SD adaptor, a USB A to micro B cable, and a heatsink; you will need to provide a power supply and an enclosure.

Επίσης σε αυτό το ράφι