Square black 80mm frame with clear blades and two-pin connector

SXDOOL

SXDOOL F128025SH 80mm 12V case fan

SKU CH-F1GF-XWB4D MPN F128025SH

80mm 12V case fan with oil bearing and 2-pin connector for compact cooling

Fan Size80mm
Power Connector2 Pin

Compact 80 mm frame fits tight chassis spaces
12 V operation powers directly from standard headers
Low 0.19 A draw keeps system power budget low
Oil bearing runs quietly for everyday cooling
Simple 2-pin connector installs in seconds

10,99 $

0.00013956 BTC με τη σημερινή ισοτιμία

Διαθέσιμο · αποστολή σήμερα

Το ταμείο κλειδώνει την ισοτιμία σας για 30 λεπτά.

Παράδοση προς Ηνωμένες Πολιτείες εκτίμηση

UPS Worldwide Expedited 3–6 εργάσιμες ημέρες 39,90 $
DHL Express Worldwide 2–3 εργάσιμες ημέρες 74,90 $

Προσθέστε 388,01 $ ακόμη και η βασική αποστολή γίνεται δωρεάν.

Οι εισαγωγικοί δασμοί επιβάλλονται κατά την άφιξη από τη χώρα σας.

Αποστολή αλλού

Compact 80mm cooling fan for tight builds

The SXDOOL F128025SH is an 80mm case fan designed for small-form-factor cases or legacy systems that need a direct 12V replacement. It draws 0.19A and uses an oil bearing for quiet, reliable operation in constrained spaces.

Slim 15mm profile with two-pin power

At just 15mm thick the fan fits where standard 25mm units cannot, while the 2-pin connector plugs straight into a motherboard or controller header without PWM control. The oil bearing keeps friction low during continuous running.

Check header type and mounting room before ordering

Verify that your board or fan controller provides a 12V two-pin header, because this unit has no third wire for speed reporting. Also measure the available depth — only 15mm is needed, but adjacent cables or brackets must not block the slim frame.

Βασικά χαρακτηριστικά

Compact 80 mm frame fits tight chassis spaces
12 V operation powers directly from standard headers
Low 0.19 A draw keeps system power budget low
Oil bearing runs quietly for everyday cooling
Simple 2-pin connector installs in seconds

Προδιαγραφές

Fan Size	80mm
Power Connector	2 Pin

Ερωτήσεις για αυτό το προϊόν

Does the 2‑pin connector support PWM speed control?

No, the 2‑wire 2‑pin interface only provides constant 12 V power; there is no PWM signal wire for variable speed control.

Will the 15 mm thickness fit a standard 80 mm mounting hole pattern?

Yes, the 80 × 80 mm frame matches the usual 80 mm hole spacing, but the fan is only 15 mm thick instead of the more common 25 mm, so verify clearance in your case.

How do I connect the fan so it runs at full speed?

Plug the 2‑pin connector directly onto a 12 V fan header or a Molex adapter; the fan draws 0.19 A and will spin at its rated speed without any software setup.

Επίσης σε αυτό το ράφι