暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料（保険付き）。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料（保険付き）。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン
Square black 80mm frame with clear blades and two-pin connector

SXDOOL

SXDOOL F128025SH 80mm 12V case fan

SKU CH-F1GF-XWB4D MPN F128025SH

80mm 12V case fan with oil bearing and 2-pin connector for compact cooling

  • Fan Size80mm
  • Power Connector2 Pin
  • Compact 80 mm frame fits tight chassis spaces
  • 12 V operation powers directly from standard headers
  • Low 0.19 A draw keeps system power budget low
  • Oil bearing runs quietly for everyday cooling
  • Simple 2-pin connector installs in seconds

Compact 80mm cooling fan for tight builds

The SXDOOL F128025SH is an 80mm case fan designed for small-form-factor cases or legacy systems that need a direct 12V replacement. It draws 0.19A and uses an oil bearing for quiet, reliable operation in constrained spaces.

Slim 15mm profile with two-pin power

At just 15mm thick the fan fits where standard 25mm units cannot, while the 2-pin connector plugs straight into a motherboard or controller header without PWM control. The oil bearing keeps friction low during continuous running.

Check header type and mounting room before ordering

Verify that your board or fan controller provides a 12V two-pin header, because this unit has no third wire for speed reporting. Also measure the available depth — only 15mm is needed, but adjacent cables or brackets must not block the slim frame.

特長

  • Compact 80 mm frame fits tight chassis spaces
  • 12 V operation powers directly from standard headers
  • Low 0.19 A draw keeps system power budget low
  • Oil bearing runs quietly for everyday cooling
  • Simple 2-pin connector installs in seconds

仕様

Fan Size80mm
Power Connector2 Pin

この商品に関する質問

Does the 2‑pin connector support PWM speed control?

No, the 2‑wire 2‑pin interface only provides constant 12 V power; there is no PWM signal wire for variable speed control.

Will the 15 mm thickness fit a standard 80 mm mounting hole pattern?

Yes, the 80 × 80 mm frame matches the usual 80 mm hole spacing, but the fan is only 15 mm thick instead of the more common 25 mm, so verify clearance in your case.

How do I connect the fan so it runs at full speed?

Plug the 2‑pin connector directly onto a 12 V fan header or a Molex adapter; the fan draws 0.19 A and will spin at its rated speed without any software setup.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。