SanDisk
SanDisk Cruzer Blade 8 GB USB 2.0 USB flash drive Black SDCZ50-008G-B35
391,99 $
0.00502958BTC
Laos
A-Tech
A-Tech Supermicro Certified 4GB DDR3 1600 CL11 1.5V 240-Pin DIMM
A 4 GB DDR3 1600 CL11 DIMM certified for Supermicro systems, running at 1.5 V with 240 pins and Hynix chips
- Capacity4GB
- SpeedDDR3 1600 (PC3 12800)
- Tested Frequency1600
- CAS LatencyCL11
- Voltage1.50V
- ECCNo
- Supermicro certified for guaranteed system compatibility
- 4GB DDR3 1600MHz boosts multitasking responsiveness
- CL11 latency at 1.5V standard voltage
- 240-pin unbuffered DIMM fits desktop slots
- Hynix chips tested for reliable operation
Supermicro Certified DDR3 1600 Module
This 4 GB DDR3 1600 DIMM carries Supermicro certification and runs at the standard 1.5 V JEDEC voltage. It is built with Hynix chips in a single-rank 2Rx8 layout and uses an unbuffered non-ECC design for desktop platforms. The 240-pin form factor fits the DDR3 slots found on qualified Supermicro systems.
Suited for Supermicro desktop upgrades
The module targets owners of compatible Supermicro workstations or servers that specify PC3-12800 unbuffered memory. It is not intended for platforms that require registered or ECC DIMMs, nor for boards limited to lower DDR3 speeds. Buyers should confirm their system's qualified-vendor list before ordering.
Certified compatibility replaces guesswork
Supermicro validation means the stick has passed the vendor's own qualification suite, reducing the risk of POST failures or timing mismatches. No heat spreader is included, so airflow in dense chassis remains unimpeded. The package contains only the memory module itself.
Põhijooned
- Supermicro certified for guaranteed system compatibility
- 4GB DDR3 1600MHz boosts multitasking responsiveness
- CL11 latency at 1.5V standard voltage
- 240-pin unbuffered DIMM fits desktop slots
- Hynix chips tested for reliable operation
Tehnilised andmed
| Brand | SuperMicro |
|---|---|
| Series | Supermicro Certified |
| Model | MEM-DR340L-HL01-UN16 |
| Capacity | 4GB |
| Speed | DDR3 1600 (PC3 12800) |
| Tested Frequency | 1600 |
| CAS Latency | CL11 |
| Voltage | 1.50V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Features | Supermicro Certified MEM-DR340L-HL01-UN16 (Hynix) |
| Recommend Use | Compatible Supermicro Systems |
Küsimused selle toote kohta
Does my motherboard need to support DDR3 1600 PC3-12800 1.5V unbuffered non-ECC 240-pin DIMMs for this module to work?
Yes, the board must accept DDR3 1600 PC3-12800 1.5V unbuffered non-ECC 240-pin DIMMs; check your system manual for the supported memory list before purchase.
Can I mix this 1600 MHz CL11 module with slower DDR3 DIMMs already in my system?
The module will run at the speed of the slowest installed DIMM; mixing with lower-speed DDR3 is possible but overall memory frequency will drop to the lowest common setting.
How can I confirm the stick is running at 1600 MHz CL11 after installation?
Check the memory frequency and timings in BIOS or a system-information utility; they should report 1600 MHz and CL11 when the module is operating as specified.
Veel samast osakonnast
Kliendid võrdlesid neid ka
Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.
